What Gauge Wire Should be Used to Wire Trailer Brakes
Question:
Hi, etrailer recommends to using Deka 10-2 gauge wire for running electric brakes to a tandem axle trailer. If this is the case, why does 7-way harnesses with molded plugs only have 12 gauge wiring for the brakes? Tghanks,
asked by: Ray S
Expert Reply:
That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary. On a smaller trailer with a single axle of brakes 12 gauge wire would probably be enough. But for a longer tandem axle trailer I would recommend you run 10 gauge wire to all the assemblies just to minimize the amount of resistance that would be on the circuit.
Also, be sure to use clean metal surfaces for your grounding locations.
Product Page this Question was Asked From
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 6 - 10 Feet Long
- Plug and Lead
- 7 Round - Blade
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Jacketed 2 Wire (Brake Wire) - 12 Gauge - per Foot
- Shop: Deka Jacketed 2 Wire, 10 Gauge, Brake Wire - per Foot
- Shop: Trailer Wiring
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Video: Hayes Air Actuated Trailer Brake Controller Review
- Shop: Mounting Bolts and Hardware for 12" Brake Assemblies
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Trailer Hub & Drum Assembly - 6,000 lbs Axles - 6 on 5-1/2 - Nev-R-Lube
- Q&A: How To Tell Apart 5,200 lb, 6,000 lb and 7,000 Axles
- Search Results: 700 15 lt tire
- Shop: Replacement Head Assembly for Reese M5 5th Wheel Trailer Hitches - 20,000lb, 27,000lb, and 32,000lb
- Shop: Easy Grease Trailer Hub and Drum Assembly for 5.2K & 6K Axles - 12" - 6 on 5-1/2 - Pre-Greased
- Search Results: wire
- Search Results: trailer connectors trailer wiring
- Video: Deka Wiring 12-2-1 Review
- Shop: Towing Mirrors
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: tekonsha trailer brake controller
- Search Results: temperature sensor
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Video: Review of BulletProof Hitches Mud Flaps - Adjustable Mud Flap System - BPH36VR
- Shop: Trailer Hitch
- Video: Deka Jacketed 10 Gauge Wire Installation
- Search Results: hub assembly
- Video: Dexter Electric Trailer Brake Kit Installation 23-26
- Q&A: Why is 10 or 12 Gauge Wire Recommended for Electric Brake Assemblies