Customers compare AM3664-2516 to these similar products
Products Featured in this Video
Today we're taking a look at the replacement nylon cap for hitch balls. Now, this unit replaces the nylon cap for your two and 5/16-inch diameter greaseless hitch ball that came on your Andersten ball mount. The nylon cap keeps the trailer coupler from binding and kinking when it's connected to the hitch ball. So when your coupler's connected, this nylon design allows really smooth transition and… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Your leaf springs are already over the axles, so you have a couple of options. You can go with a lift kit or you can replace your axle hangers. The tandem axle lift kit that will work with your trailer is the Lippert Components Tandem Axle Lift…
view full answer...Thank you for the photo of your food service trailer. It is a bit hard to tell for sure but it appears you have 8-lug wheels of the conventional steel type. If you are looking for decorative center caps for these wheels you can refer to the linked…
view full answer...To be completely honest the sway control feature of the B and W Continuum part #BW78FR isn't nearly as advanced as the rest of the system. The advertised sway control of this system is in the head of the system between where the ball…
view full answer...If you are referring to two white wires from the brake magnet that are coming from the rear of each electric brake assembly, then it would not matter which wire is connected to ground and which wire is used for the brake feed. The magnet that…
view full answer...Not all aluminum trailer frames are strong enough for use with a steel weight distribution (WD) system. It is possible that the stronger steel WD components could put too much stress on the frame. If your trailer has an aluminum frame…
view full answer...Yes you can just purchase the motor, in this case for your Lippert Model 1-065-041012-01, would be the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893. This motor has a maximum load capacity of 5,000lbs and is rated…
view full answer...I reached out to my contact at Lippert and since your landing gear motor is blowing a fuse as soon as it sees load he mentioned the issue is more than likely that the motor is not getting the correct voltage, with the less common cause being the…
view full answer...The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice.…
view full answer...If you still have the plunger end that goes in the break away switch, then you can simply insert the plunger back into the switch and that should cut off the power to the brakes on your trailer. If you no longer have the plunger, then you can…
view full answer...If the bevel gears/gearbox for the dual-motor landing gear on your 2011 Keystone Laredo 266RL 5th wheel were badly worn or damaged you would most likely be able to hear it. These conditions typically cause a good bit of noise as the jacks try to…
view full answer...When a trailer jack has to do more work it will draw more power. If it draws excessive power then the fuse will blow. Something is causing the motor to draw excessive power. If the weight of the trailer has not changed then it could be a wiring…
view full answer...As long as the 2016 GMC Yukon Denali has 4WD with a two-speed transfer case that has a Neutral and 4 wheel drive low setting, you can flat tow it with all 4 wheels on the ground behind the 2018 Allegro Bus. If the GMC has 2WD, it has to be towed…
view full answer...