Sealed Pressure Switch for Bulldog Winch Air Tank - 110 to 145 psi

Video Transcript for All You Need to Know About the Sealed Pressure Switch for Bulldog Winch Air Tank

Today we'll be taking a quick look at the sealed pressure switch for Bulldog Winch Air Tank.This is going to maintain a pretty constant level of pressure inside your air tank for your compressor system. This is going to keep it between 100 psi and 140 psi. Whenever it gets down to 110 psi, it'll kick that compressor on, fill up the tank, and then it'll automatically turn off at 140 psi.This is a sealed switch, so it can be mounted underneath your vehicle without any risk of getting damage from water, or debris, from getting kicked up from the road. And it's going to mount directly to your tank, so it can read that pressure. And then the wires will be connected into your compressor.We'll have two wires coming off the back there again. It all nice and sealed up.

Comes with this little cap in transit so that there's no gunk or debris that can get caught in that pressure switch and cause any issues.The threaded end here has an NTP thread of a quarter inch. It measures about two and a half inches long, and then it's roughly an inch and an eighth in diameter. Our wire leads coming off the back are about five and a half inches long. Max amps with this is 30 amps. Again, our restart pressure, 110 psi, that's when it'll turn on.

And then it'll turn off at 145 psi of pressure.Has a one year limited warranty from Bulldog Winch, and it works with 12 or 24 volt systems. That's going to do it for our look at the sealed pressure switch for Bulldog Winch Air Tank.