Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This replacement control module is the brain that enables your single, double, or triple electric Lippert Coach Step or Stromberg Carlson sliding step to function properly. It attaches underneath the step's base with 4 screws (not included).
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the Replacement Control Module for an Electric Coach Step. This replaces the control module that came standard on your single, double, or triple electric Lippert Coach Step, or Stromberg Carlson Sliding Step. This unit simply houses the circuits and electrical components necessary for the step to function properly. It's going to include the weatherproof wiring and connectors. It installs underneath the base of your step with four self-tapping screws. The screws are not included, but when you're ready to install this, you'll remove the self-tapping screws holding the ground wires on your previous module. Then you'll need to disconnect the four pin connector to the motor wiring harness, that will look just like this one.
Disconnect the two pin connector to the motor, it's going to look just like this one. Remove the self-tapping screws holding your module in place, and simply install the new module in reverse order. A few measurements to go over with you real quick and then we're going to go over a few of the wire functions. Edge to edge going this direction, it's going to give us a measurement of 5 13/16". Going this direction, just measuring the box portion, that's going to be 4 1/8". The holes are separated on center going this direction by 3 1/8", and the hole separation on center in this direction, is going to be 5.25". Really nice design.
Again, you're going to have your four pin connector, goes to the motor wiring harness. Two pin connector that goes directly to the motor and then your black wire right here, this is going to be the wire that gets connected for the step light. You're going to have two green wires, these are both ground wires. One grounds the chassis, the other one grounds to the steps. Then your purple wire, located right here, this is going to be for the step light switch.
That's going to do it for today's look at the Replacement Control Module for an Electric Coach Step. Again, this replaces the control module that came standard on your single, double, or triple electric Lippert Coach Step or Stromberg Carlson Sliding Step.
Average Customer Rating: 4.8 out of 5 stars (182 Customer Reviews)
This replacement control module is the brain that enables your single, double, or triple electric Lippert Coach Step or Stromberg Carlson sliding step to function properly. It attaches underneath the step's base with 4 screws (not included).My wife and I lived with our entry steps intermittently failing to retract for far too long. We are thankful that we didn’t end up damaging them. More thankful for the excellent product from etrailer.com. Perfect replacement for our 20 year old Monaco.
Excellent control module. Everything worked when the steps were mounted and plugged in. Very happy with your service. I was able to track my package across the US and Canada. Arrived on time that was stated.
Product worked as expected however wiring for step light was a bit confusing and customer service only had a partial answer so I still dont know how to wire the light up
the product was shipped and received at my temporary RV location very rapidly. it worked when i installed it since i was armed with some slight installation tips from product reviews. well done! i always like dealing with etrailer.com cheers. Gene from the Sturgis Motorcycle Rally...
Easy to replace and was a perfect fit.
The new replacement module was perfect. Installation was a breeze and now I realize that my old control module was creating more problems that I knew about. Highly recommend this product.
Worked perfectly!
My 2006 Monaco Diplomat steps stopped retracting and extending completely and reading on etrailer website found others with same problem. Called etrailer to order the correct step module and received it quickly. The module item number was LC301702 and it matched all the plugins and wires except there was a purple wire that was not necessary for my unit which I capped off. Thanks for the help!
Bill
12/12/2022
Works great and is a better design than the original is sealed to keep moisture out of the electronics. It also fit perfectly.
Excellent customer service from Mike B, the part was a perfect replacement and fixed my problem, thanks for another great transaction.
Always easy and fast...
your video was most informative, (better than written directions), however the unit i am replacing did not have a separate swithch wire (purple) so I am unsure haow or where to connect. I have a 2006 Forest River Lexington with a Coach Step one step setup. please advise.
Part works great and was the correct one etrailer had recommended as the replacement needed.
I have a 2006 DutchStar. This product was as close to an exact replacement as you can get. The customer service from etrailer was awesome as they checked with Lippert mfg before I order just to make sure it would work and even sent me a pdf of the wiring diagram so I could figure out the install. I was on the road and staying at a KOA, shipping was fast and the box was well enough marked that there was no problem getting it when it arrived.
Richard H.
4/26/2019
actually ... its been two years. No issue since the install!!!
Very pleased with staff and service at etrailer! They were helpful in determining the proper product. Received the part very quickly and installed it. But....then realized it was not compatible with the door magnets; however, was able to get the right magnets and send out immediately. Very pleased that the problem was rectified so quickly.
Len P.
6/7/2018
So far...so good.
current step no longer operated when opening and closing door, replaced with sp -164889 electrical box , part arrived quickly and within 30 minutes had this installed and steps working like new . great service
Randy C.
2/20/2018
STILL WORKING GREAT!!!
ON TIME AND RIGHT PART! CANT ASK FOR BE TTER!
Steps are working like they should.
All went together great works perfect
Great job thanks
The control module for the electric step on our RV stopped working because it became corroded from sprayed sand and water. The new unit is much better designed and fully insulated against a repeat of the problem. It works very well and was delivered as promised. I am pleased with the service.
Don S.
8/1/2018
Thank you for reminding me that I had purchased the Lippert Components Accessories. I am pleased to report that it has worked perfectly from the date that I installed it. The delivery was on time and the instruction information helpful. All told, I am pleased with the service and the improvement in the module. It is greatly improved.
Product is RV step controller, and was an exact replacement for old device. Fit perfectly, and works as it should. Be careful of motor plug orientation--if wrong, device opens/closes door opposite correct way. Price was good.
Gene
2/11/2020
Working as it should.
The step controller was the right one, and was verified during order placement. Said it would be there by Friday, but came on Monday. $xxx cheaper than PPL for the exact same controller.
The module we received worked fine & the service at etrailer was outstanding. They go the extra mile. The module was for our motor coach step.
Joyce
2/14/2019
It works great & we are really happy with your service.
Its been a few months since receiving the new controller. I finally got around to installing it. All seems to work well! Fixed old controller problems so far!
Dan
11/8/2022
The step controller has been working great! No problems!
Received the LC301702 control box quickly and installed. This control box resolved my inoperable step problem. I have the Double Coach step installed on my 2005 Newmar Kountry Star DP. On my installation the purple and black wires for the step light were not required. I taped and seal the ends of those wires, attached the control box ground wires one to the step and one to the frame then plugged in the two wiring harnesses as shown in the video. Bam my steps are operational again. Thanks E-trailer.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Brooke M.
2/29/2024
Thanks for the video, thats awesome! Love the color of your guys RV!