Replacement Brass Grease Zerk for Weld-On Hinges - 8 MM x 1.00 Fine

Video Transcript for Review of Marlboro Replacement Brass 8mm Grease Zerk - MA95ZR

Hi there, I'm Michael with etrailer.com. Today, we're gonna take a quick look at this Replacement Brass Grease Zerk. This grease Zerk is going to replace the grease Zerk that originally came on your weld-on hinge, so that you can easily lubricate that hinge again, make sure that everything's gonna be working operationally. This allows for a nice smooth hinge operation by allowing you to just quickly hook up your grease gun and put some lubrication on the pivoting pin. This is an eight millimeter by one thread here, so make sure that that is going to be the right size for you, there's also a six millimeter option, so if yours is a little bit smaller than this, it's probably that one, you can find that available here at etrailer.com as well. Just to give you a few quick measurements here, you can see this is right about 5/8 of an inch long, and our width, when I measure it, I'm gonna say it's 5/16 of an inch thick with our nut portion there that we will use to tighten it down.

So if you are needing to replace the grease Zerk for your weld-on hinge, make sure that it is going to meet that size pattern, and if it does, this is gonna be exactly what you need, it'll do a good job of allowing you to grease up your hinge again, so that everything works properly. So that's gonna complete our look for today. Again, I'm Michael with etrailer.com. Thanks for watching..