Replacement Hose Mounting Clip for Yakima RoadShower

Video Transcript for What to Know About the Replacement Hose Mounting Clip for Yakima RoadShower

If you have the Yakima RoadShower, we have replacement parts here at etrailer. The one we're looking at today is going to be the little retainer for our hose. Most likely it's probably just fallen off because it is made of aluminum, but it's gonna come with a replacement piece and also the screws. So we're gonna show you how to replace it real quick. Pretty straightforward. We just need to take the screws out, and try not to lose 'em, but if it's already just missing, we wouldn't have to remove what we got here.

We're gonna take this out and remove it. And if you still have the original hardware, you can use that. And then we can take the new piece with the new hardware, and thread it back in. It's the same pitch and the same length screw, so it should go in there relatively easy, so don't force it. We don't want to cross thread anything.

But it's just as simple as that. All you need is a Phillips screwdriver to tighten this all the way up. And once it's in place, make sure it's still nice and tight. And then you're good to go to put your hose back where it needs to go. There's not a whole lot to this product.

It's literally a mimic of what comes on the RoadShower. So if you need replacement parts, we have that part and many others for the RoadShower. So etrailer's got you covered. That's pretty much it for our look at the replacement retainer for our hose on our Yakima RoadShower..