Replaces the foot for your etrailer or Ram electric jack (EJ-3520-BBX or EJ-3520-WBX).
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hey, everybody. I'm Ellen here at etrailer.com and we're going to be looking at the replacement foot for your etrailer or ram jack. This is a round drop leg foot for your jack to make sure that it's going to have a stable place to rest and not sink straight into the ground. It helps to disperse out that weight, so it can stand and make sure it doesn't sink down into gravel or dirt or anything else that might be a little bit softer ground. So let's take a closer look, make sure it's the right fit for you. It does have a groove running the length of the foot to make sure that it doesn't twist, it helps to make sure that it stays in one spot.
That helps to make it easier also to line up our attachment holes or adjustment holes there.Does not come with the pin, so you'll have to reuse the pin from your original setup. This again works for your etrailer or ram electric jack. The part numbers for those are listed on the product page. I'll give you a few measurements just for reference. So this jack is about one and three quarter inches in diameter.
The mounting holes or the adjustment holes are spaced apart by two inches center to center, and there are four total. The foot is about five and a half inches in diameter and it's about nine and a half inches tall overall. That's pretty much all there is to it for our look at the replacement foot for your etrailer or ram electric jack. I hope this has been helpful in deciding if this is the right replacement part for you. We do have a lot of parts for jacks and trailer accessories here at etrailer.com, so check them out.
Thanks for watching.
Average Customer Rating: 4.7 out of 5 stars (15 Customer Reviews)
Replaces the foot for your etrailer or Ram electric jack (EJ-3520-BBX or EJ-3520-WBX).The product was satisfactory and, as stated above, works as advertised. I gave it 3 stars basically because the weld between the round base plate and upright tube was not fully continuous all the way around the base. I’m sure that the weld, as-is, is more than adequate but in my opinion it could have been a neater job. However, no problem because the drop foot functions as it is supposed to.
Service was fast and the order was correct. I will use you again!!
Nice looking didn’t realize it was Crome plated
Fast shipping! Thanks!
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.