CargoSmart Tool Holder for E Track and X Track Systems - Steel

Video Transcript for Let’s Check Out the CargoSmart Tool Holder for E Track and X Track Systems

Jake: Hey guys, it's Jake from etrailer. Today I'm going to be showing you a little bit more about the CargoSmart Tool Holder for E-Track and X-Track. This is going to be able to let you organize your hand tools that you frequently use, whether it be in your garage, in a trailer or, in the bed of your truck. As you can see here, we have a mallet, a couple of different hammers and some screwdrivers and a bunch of hand tools back here. These are tools that we would all frequently use in our daily work, or any projects that you have going at the time, that you don't want to put them all the way back in your toolbox so you have to look for them again. You can put them on this shelf, temporarily, and then they're there for when you need them.Well, let's go ahead and get all our tools off so we can get a better look at the design of it.

As you can see here, we have a wide variety of different size holes. We have these larger holes that are going to be for bigger tools or hammers, or anything like that, and then on the center here, you're going to have anything, like for a pliers, a diagonals or wire strippers, anything like that. All these holes here, are for your different type screwdrivers, whether it be a larger tipped screwdriver or a smaller tipped screwdriver. It's just going to help you get more organized, and be able to have your tools ready for when you need them.In my personal opinion, the nicest thing about this tool holder, being compatible with E-Track and X-Track is that when you're ready to remove it from the wall, if you're not using it, you can just simply pull these two tabs and pull it out. And now what I like to do, is I like to take this empty rack over to my tool box, and if you're working on any specific project, you're assembling anything, reassembling something you took apart, you can take this over to toolbox, fill it up with the tools that you need, and then bring it back and then clamp it into place, and now you know you have all the tools that you need for that project.It's going to have a nice, one-eighth inch thick steel construction, it's going to be very durable and hold up to whatever tools you might be putting on it.

It's going to be zinc coated, so it's going to have a nice slick look to it and hold up to rust and corrosion. One little note about this tab here on the front, it's actually going to act as a stop, so if you're simply using this as a shelf to hold your tools, you can set your tools down, that may have a tendency to roll, and they're not going to roll off the end of your shelf.So here's a few measurements for you guys. From the outside edge of our X-Track here, it's going to be about six inches to the outside edge here. On the inside, usable space, it's going to be about five and a quarter inches, so that's how much shelf space you're going to have. With all that being said, I hope the CargoSmart Tool Holder helps you keep your tools more organized..