To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Install a Companion fifth-wheel hitch in your truck bed with this custom kit. Better than a traditional mounting kit, this setup doubles as a gooseneck hitch when the fifth wheel is removed, and the underbed design allows for full bed access.
Features:
Not only does this kit provide you with a sturdy, custom base for installing your Companion fifth-wheel trailer hitch in the bed of your truck, but it also doubles as one of the most recognizable gooseneck hitches on the market. This fifth wheel installation kit actually is the Turnoverball gooseneck hitch from B&W.
Gooseneck Specs:
With the B&W Turnoverball underbed gooseneck trailer hitch you get the best of both worlds. When you go to tow a gooseneck trailer, the Turnoverball creates a sturdy, dependable connection with your trailer. And when you're done towing, you can stow the ball upside down in the hitch to get full bed access and a clean appearance. When you're ready to tow your fifth wheel trailer, just install the Companion in the ball hole in place of the gooseneck ball and lock the post in place using the built-in handle. You can remove the fifth wheel when you're done towing, leaving your truck bed open once again.
Simple, Custom Installation
This kit is custom designed for your vehicle. The mounting brackets bolt to existing holes in your truck's frame. While some modification is required - you will need to cut a 4" diameter hole in your bed for the hitch ball and drill holes for the built-in safety chain loops - there is no need to weld onto or to drill into your frame.
Note: Because the body of your truck is constructed of aluminum, there is an increased risk of galvanic corrosion when a different metal, such as steel, contacts the truck body. To help prevent this corrosion, strips of polypropylene tape are included to provide a barrier between the steel of the hitch and the aluminum of the truck. These strips are to be applied to the center section of the gooseneck hitch as shown above.
Once you have the brackets and center section installed, set up the operating handle. This handle is designed to be accessed from the rear driver's-side wheel well. On the end of the handle is the heavy-duty steel pin that secures the mounting post of the Companion (or the base of the gooseneck hitch ball).
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Do you have a question about this Gooseneck Installation Kit?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.