Powder coated, carbon steel tube welds to your cab and chassis truck to give you a 2" receiver for towing. Can be cut and customized to act as the center section of your fabricated hitch.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we are going to take a look at the 18 inch long, two inch by two inch black weld on receive tube. These weld on receiver tubes are available in a variety of lengths, dimensions and finishes to match your towing needs. This part happens to be the 18 inch long version. This is a two inch by two inch receiver tube. The internal dimensions are two inches by two inches. It features a nice cast steel collar and a solid stress collar opening.
This 18 long finished tube contains a five-eighths inch hitch pin hole. Five-eighths inch diameter hitch pin hole and it can achieve a rating up to 20,000 pounds. It's a nice carbon steel construction. It has a black powder coat finish. It is open all the way through.
It's open on both ends and then just to measure this we go from this end to this end, is right at 18 inches long. Again, the maximum gross trailer weight capacity on this is 20,000 pounds.That should do it for the review on the 18 inch long, two inch by two inch black weld on receiver tube.
Average Customer Rating: 4.9 out of 5 stars (13 Customer Reviews)
Powder coated, carbon steel tube welds to your cab and chassis truck to give you a 2" receiver for towing. Can be cut and customized to act as the center section of your fabricated hitch.Ordered this part for my custom hitch on my 1956 Ford F100 project truck. The item was just what I needed. The part was shipped within hours of placing my order and was received in two days! I highly recommend etrailer.com and would definitely use them again.
I used this the put on my tractor to jockey my trailers around
fabrication of f450 included putting 2 hitch recievers for 2 smaller cargo baskets. to hold camping gear and still have the ability to pull a trailer
Receiver hitch arrived via surface mail in good condition and was exactly as illustrated on the website of being made of high quality steel. The product use is for a rear weld-on fifth wheel receiver hitch for a bicycle rack.
It worked perfect for my custom hitch!
WE ARE HAPPY WITH THE PART
Top quality!
Heavy and well powder coated
Do you have a question about this Hitch Fabrication Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.