Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
2-1/2" x 2-1/2" Receiver bar sized and punched to fit all common weight-distributing hitch ball mounts or utility ball mounts.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, we're going to take a look at the Curt 18-inch Long Combo Bar with the 2.5-inch Trailer Hitch Receiver Opening in an unpainted raw finish. Now this combo bar is used to fabricate a hitch receiver, where a bolt on hitch receiver is not available. This is designed to accept any 2.5-inch by 2.5-inch ball mount shank. Does have this nice half-inch forged collar reinforcement around the front here for increased strength. And as I mentioned, it is an unpainted raw finish, so it allows for immediate welding.Does have a pre-drilled five-eighths inch diameter hitch pin hole. Does require a hitch pin and clip to hold your ball mount in place, that is sold separately.
We recommend to use part number C21582, and it's listed on this product page as a related product. This part is made in the USA. Overall length on this, if we measure from the very front to the very end is right at 18 inches. And the measurement from the front to the center of the hitch pin hole is right at 2.5 inches. But that should do it for the review on the Curt 18-inch Long Combo Bar with the 2.5-inch Trailer Hitch Receiver Opening in an unpainted raw finish..
Average Customer Rating: 4.9 out of 5 stars (15 Customer Reviews)
2-1/2" x 2-1/2" Receiver bar sized and punched to fit all common weight-distributing hitch ball mounts or utility ball mounts.
After looking at pre made front hitches I decided to build my own (the ones on the market drop down below the bumper and cowling putting them about 3"off the ground) This tubing is perfect for the 2.5" winch basket I use.
Great company to deal with, the only reason I gave four stars was because when I ordered a 2-1/2” receiver tube over a 2” tube I would hope it would be a schedule 80 tube with a heavier wall. It has the same wall thickness of schedule 40 like on a 2” tube. I have bent 2” tubes in the past towing equipment so I figured I’d try a bigger size . Also the hitch drop mount is a bit loose and sloppy in the receiver tube.
I need time to work with the product.
Very well made. Really liked that it was made in the USA and was just what I needed to make a custom hitch.
Product arrived just as shown and was well pleased with e-trailer will do business again with them
Great product just what I needed. Making a set of sleeves for a Semi rig guard bumper for my RV.
Worked well fast delivery
Do you have a question about this Hitch Fabrication Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Jim
9/29/2024
It has been working on my truck hauling heavy equipment trailers with no problems. Thanks for a great product