Don't Miss These Holiday Savings!
Sturdy RV steps detach from under your camper door for tight spaces, and the legs individually adjust to uneven ground to provide a wobble-free step into your camper. Fits a threshold-to-ground height between 35-1/2" and 44".
Features:
Specs:
If you've ever stepped into a camper that has standard metal steps, you've probably felt that scary springboard effect that makes you reach for the handle. That bounce occurs because those pull-out steps never touch the ground. MORryde's Quick Connect steps have adjustable legs that steady the steps on the ground, so you can feel safe using them. Also, the steps are detachable, which means they aren't left out in the elements to rust or warp like factory steps.
But what makes these MORryde steps different from other detachable steps, the Brophy scissor steps or the TorkLift GlowSteps? The Quick Connect steps have a couple advantages over the Brophy or TorkLift steps.
First, the Quick Connect steps easily detach from the mounting brackets. This is handy if you want the sturdiness of the fold-down steps, without the inconvenience of permanently mounted steps that get in the way in tight situations. If you have to park close to another vehicle in a storage lot, for example, there might not be enough clearance to deploy your steps. With other fold-down steps, this means you can't deploy the steps and now they are blocking your entryway. The MORryde steps can be easily attached when you need them and detached and stored when the situation calls for it.
Second, the MORryde steps are fitted securely to their frame, with no folding points like on the Brophy scissor steps or the TorkLift GlowSteps. This makes them extra sturdy and less likely to bounce or move when you step on them. The camper won't rock as you climb in and out and you won't feel as though you may take a tumble at any moment while on the steps.
Snap-on steps are typically installed on travel trailers and 5th wheels. The Quick Connect steps from MORryde have two brackets that mount beneath your camper's door frame. The paddle latches allow you to clip the steps onto the brackets and to detach them for storage inside your camper.
Step 1: Measure the Entry Height
Measure from the doorway threshold to the ground. For these steps to work, you will need an entry height between 35-1/2" and 44".
If you find that you have a smaller entry height, there are other step assemblies that fit entry heights ranging from 2-1/2" to 36". (See table below)
Step 2: Measure the Mounting Space
Measure the space beneath your camper's door frame. You will need a minimum distance of 1-3/4" from the bottom of the door frame to the bottom of the camper to attach the mounting brackets.
If, after taking your camper's measurements, you find that these steps will not work for you, use the table below to determine which part number you need.
| Mounting Space | Entry Height | etrailer Part Number |
|---|---|---|
| 1-3/4" | 21-1/2" - 27-1/2" | MR85HR |
| 1-3/4" | 27-1/2" - 36" | MR63RR |
| 1-3/4" | 35-1/2" - 44" | MR25HR |
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everybody, Andy here with etrailer.com, and today, we're gonna take a look at this MORryde 4 Step Quick Connect RV steps. If you have ever stepped into a camper on those standard metal steps, you've probably felt that scary springboard effect that makes you reach out for the handle. That bounce occurs, because those pull out steps never touch the ground. MORryde's Quick Connect Steps have adjustable legs that will steady these steps on the ground, so you can feel safe and secure using them. Also, these steps are detachable, which means that they will not be left out in the elements to rust or warp like factory steps. Now, these steps fit a threshold to ground height between 35 1/2 inches and 44 inches.
These removable entry steps are going to make it easy to climb in and out of your trailer or your 5th wheel, and because they are detachable, you are not going to get locked out if you park in a tight storage lot where you can't fold the steps down. Now, to work the detachable feature of these steps, you will simply just squeeze the paddle latches that you see right here to clip the steps from the brackets that come with these steps, and you're just going to install these brackets beneath your camper's door frame with the included hardware, and again, they're gonna be very easy to attach to that bracket, and then again, when you wanna release it, you just use that quick release paddle handle. So these are gonna be very easy to use, very convenient to use. And these steps have a stable design that is going to be bounce and wobble-free, and the weight capacity is 500 pounds, and these legs extend as I mentioned earlier, they extend and they individually adjust for maximum ground contact even on uneven ground, and they have a quick release feature, and you can find that quick release button on the back of either side, and that's going to let you easily adjust. So on this end here, I'm going to push on that quick release button and just slide this leg in a little bit, and now, that is locked into place, And then when you need to pull the leg out, you do not need to push that quick release button, you just simply pull the leg out to the point where you are even, and it looks like we are even, and that's how simple it is to use this.
The leg extension length are at one inch increments for a total of 13 inches. The safety features provide traction and reduce the potential for slipping in wet conditions. You get a textured step surface and a non-slip tread tape that's going to help keep you from tripping. Now, I measured these steps earlier and the width of each step is 23 3/8 inches wide, and the three bottom steps are eight inches deep. Now, the top step is going to be 10 1/2 inches deep, so that top step is gonna give you that wider, more secure step when you step down from your camper or from your 5th wheel, so you're gonna have a nice, sure, wider step as you step down.
Again, 10 1/2 inches wide, and then the remaining three steps measure right at eight inches deep. Now, the drop/rise from the top of one step to the top of the next step, we're sitting right at nine inches. And these steps are made in the USA, and the lightweight construction makes them virtually effortless to use. The aluminum step platforms that we've been looking at together are rustproof and scratch resistant, and the powder coated steel frame is going to resist corrosion. Now, this is going to arrive to you preassembled, and again, the mounting hardware and the brackets are gonna be very easy to install.
Well, that's gonna conclude our look today, I do hope that it was helpful for you. Again, my name is Andy, thank you for joining me..
Average Customer Rating: 4.7 out of 5 stars (23 Customer Reviews)
Sturdy RV steps detach from under your camper door for tight spaces, and the legs individually adjust to uneven ground to provide a wobble-free step into your camper. Fits a threshold-to-ground height between 35-1/2" and 44".
MAJOR IMPROVEMENT over the factory fold-out steps. The stability improvement is incredible, not just for the steps themselves but for the entire camper due to the fact that these contact the ground. I prefer the quick connect style as opposed to the fold-in design due to the fact that there was no door trimming required. Construction and styling of the steps is top notch. Installation is super easy. Line up the brackets and make 4 marks, drill 4 pilot holes and attach with 4 included screws. So simple. Takes 30min or less from unboxing to installed. This is by far the best upgrade I've made to my camper so far. etrailer is awesome!!
Great product , good price ,
Fits well , installation instructions were for a different model, may be an issue for some .
Really enjoy the new MORryde quick connect steps on my Rockwood Roo 233s. No more bouncing stairs. Dealing with etrailer.com has been a great experience.
Awesome steps, matched description perf ectly
These steps are very Durable and they added a sense of safety that our 1984 Kit Companion camper desperately needed! Easy to install - 15 minutes total! It didn’t come with the pins that keep the legs from sliding out. We purchased these at hardware store. The directions were not good either. For these 2 reasons we gave it 4 stars!
The leg adjustment feature of these steps is horrible. The pin and hole style is certainly not a design from this century or the last. A simple threaded knob friction type set-up would be a vast improvement. Adjusting them every time to account for different ground situations is a miserable task. I don't use them any more and went back to a 1st century invention; the step stool. Not perfect... but better in my opinion.
Great customer service. Very helpful with my order.
4 EVRYTHING WENTWELL THANK YOU
Love these sturdy stairs. Had to redo the spring function on one side because the spring wasn’t activated.
Took less than 20 minutes to install. They are a great improvement over the factory steps.
Built better then expected. Have not installed yet
Do you have a question about this RV and Camper Step?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.