Sensor adheres to the outside of your RV's holding tank to measure its fluid levels, and it sends those readings to a SeeLeveL monitor (sold separately) inside your RV. Sensor can be cut or stacked to fit the height of your tank.
Features:
Specs:
Note: SeeLeveL tank monitoring systems are not compatible with metal tanks.
Traditional tank monitors have a reputation for being unreliable. Only a few sensors are installed inside, meaning that they usually only measure in quarter increments and can send false readings if they get dirty. When you're keeping an eye on how much fresh water you have, the difference between 25% full and empty means a lot, and that inaccuracy can be a problem.
The SeeLeveL tank monitoring system uses technology that can sense fluid levels from the outside of the tank. The sensors' flexible circuit board sticks in place and measures along its entire height. This makes it accurate in single-digit increments.
Easy Install
If you're comfortable with basic wiring, installing the SeeLeveL monitoring system should be a straightforward DIY project.
A single 6" sensor can measure a tank as tall as 7". For a shorter tank, the sensor can be trimmed. Unlike the 12" and 16" SeeLeveL sensors, the 6" sensor cannot be stacked for taller tanks. If your tank is taller than 7", use a taller sensor.
Sensor Options | ||
---|---|---|
Tank Height | Best Resolution | Other Acceptable |
4-1/2" - 5" | (1) 6" | - |
5" - 7" | (1) 6" | (1) 12" |
7" - 13" | (1) 12" | (1) 16" |
13" - 17" | (2) 12" | (1) 16" |
17" - 25" | (2) 12" | (2) 16" |
25" - 34" | (2) 16" | - |
Part numbers: 6" (SE77VR), 12" (SE87VR), 16" (SE27VR) |
To get the best resolution for the highest accuracy, choose the right setup. The segments along the left side of the sensor have 4 read points each. The more of those segments you have, the better the accuracy. Even with the lowest resolution possible, you will get tank readings accurate within 8%.
After some surface preparation, the sensors are attached to the tanks with 3M adhesive backing. Splice together all signal wires and all ground wires from the sensors, and run those two wires through your RV to the monitor inside. If you're replacing an old tank monitoring system, the existing wiring can be used.
Average Customer Rating: 4.8 out of 5 stars (6 Customer Reviews)
Sensor adheres to the outside of your RV's holding tank to measure its fluid levels, and it sends those readings to a SeeLeveL monitor (sold separately) inside your RV. Sensor can be cut or stacked to fit the height of your tank.these sensors were very easy to instal, after locating and cleaning the tank surfaces... the single wire design, that included the LP tank guage, really made for a quick installation... I would highly recommend these..
etrailer upheld its high standard of customer service. They fixed the problem on their side. I still have to install new sensor to replace the one that was damaged due to incorrect info given initially.
It was fast shipment. Thanks
Great price, had to wait for product to be in store but the price was to good to past up so we waited
Do you have a question about this Smart RV?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.