Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 15-1/2" Travel - 7K

Video Transcript for In-Depth Review of the Round, Pipe Mount Swivel Jack w/ Footplate

Hello neighbors. It's Brad here at etrailer. And today we're taking a look at the etrailer round, pipe mount, side winders, swivel jack. Now we have our trailer here and this is used to haul four wheelers or side by sides around. So it's not a ton of weight, but we wanna make sure we have a jack that's able to support that. And this is a pretty heavy duty one.

It comes in at 8,000 pounds of supporting weight. Now you can actually lift 7,000 pounds with it. So overall with this trailer, even loaded up this should be able to hold up to that weight with no problem. Now, having a sidewinder jack is really nice because you're easily able to access this. Some of your top mounts you can kind of get some clearance issues and run the risk of bumping your knuckles.

Or even if you store anything up here, they can kind of get in the way. The side winder is really nice because again, if you can get to the side of your trailer you're able to crank it up nice and easy. Now, speaking of that, you have 15 and a half inches of travel, and that's gonna be a decent amount of movement. Considering the height when fully retracted is gonna be 15 and three eights. So pretty short, but also it can extend up to 31 and one eight.

So you can really get a lot of reach. So it's gonna encompass a lot of options for different heights of trailer couplers. I really like the pipe mounted jacks because it gives you the opportunity to be able to swivel this up with the pull of a pin. And that's gonna give you a ton of ground clearance. So it's really nice cuz some of your other jacks you can crank and crank and crank and you're gonna get that ground clearance but sometimes they still hang a little bit lower and I'm always kind of worried that they're gonna bottom out if we hit a big bump.

Well, this kind of gets this all outta the way. Nice and easy. And also if you're kind of used to the height and the same truck that you're using, it's pretty great. You only have to raise it up just a little bit. And then when you're ready to actually put this down you can just simply swivel it down and it's gonna be right there just with a few cranks rather than have to keep going at it, to gain that distance. Now, as far as mounting it up, it is going to fit onto a two inch pipe mount here and this one already has it but it also includes a female style. So it's a little bit larger here, but you'll just weld that onto your trailer and that's gonna allow you to kind of custom mount it wherever you want. Now, when it comes to a jack, really, you just want one that's gonna be working well every time you use it. And this is gonna be nice and easy as far as maintenance to make sure that it works every time. You have a built in greaser, which is really nice, just a couple pumps of grease every once and again, and it should keep it nice and protected. Going along with that, black powder coat finish is gonna keep it looking really nice. And also all of our metal that you see here is zinc coated. So long term rust and corrosion resistant. So it's gonna look really nice. It's also not gonna get any build up here and cause any binding as you're raising a lowering. The foot plate is also coated in that zinc as well. So that's gonna stay looking nice. And this is a one piece welded on foot plate. So one less thing that you have to worry about rattling around or losing. So this is is all one piece. And that was a look at the etrailer round, pipe mount, side winder, swivel jack..