Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Shank fits 2" hitches and offers rise and drop. System uses optimal points of tension to help prevent sway while it balances your trailer's load for a more level ride. Clamp-on brackets require no drilling.
Features:
Specs:
Included w/ BXW1000 | Required - Sold Separately | Optional Add-Ons |
---|---|---|
| n/a | n/a |
Create a stable ride for your tow vehicle and trailer with a weight distribution hitch. Adding spring bars to your towing system applies leverage, which transfers the load that is pushing down on the rear of your vehicle to all the axles on both your tow vehicle and your trailer, resulting in an even distribution of weight throughout. The result is a smooth, level ride, as well as the ability to tow the maximum capacity of your hitch.
The tongue weight rating is the most important factor in determining which size weight distribution system you should use. If the bars of the system you choose are rated too high for your setup, they will create a rigid ride, which can result in a bouncing trailer. If, on the other hand, the bars are not rated high enough, the system will be unable to properly distribute the weight, rendering it virtually useless.
To determine the proper weight rating for a weight distribution system, you must first determine your trailer's tongue weight. Then add to that the weight of the cargo behind the rear axle of your tow vehicle. These two measurements make up the tongue weight rating for a weight distribution system.
Other weight distribution systems have lift brackets that require you to apply a good amount of leverage to get them to snap up, which can be difficult and frustrating. With the SwayPro, all you have to do is insert the lift chain into the bracket slot and rotate the bracket with the included wrench until the lock pin engages.
Another feature of the SwayPro is the easy-to-use head. The required pitch is already built into the head, so the only adjustment that may be needed is the placement of the head on the shank. Move the head up or down along the weight distribution shank to achieve the proper height. No additional, fine-tune adjustment is needed, which means no hard-to-access washers or difficult-to-use thumbscrew.
The SwayPro offers four points of built-in sway control. Within the head assembly, the trunnions are designed to hold the spring bars securely in position, placing just enough tension on them to cause them to constantly force your trailer in line. At the other end of this weight distribution system, the rotating brackets ensure that the lift chains are pulled as taut as possible. In addition, the basic design of the brackets keeps much of the length of the lift chains wrapped up inside of the brackets. Typically, only a couple of links hang down from each bracket. So each chain is held more stable than in traditional weight distribution systems, where more than twice as many links are exposed. This tight, stable design limits the movement of the spring bars so that they can exert more force on your trailer to effectively keep it from shifting side to side. Furthermore, unlike many friction-style sway controls, the SwayPro allows you to back up your trailer without having to remove or disengage the system.
Average Customer Rating: 4.6 out of 5 stars (401 Customer Reviews)
Shank fits 2" hitches and offers rise and drop. System uses optimal points of tension to help prevent sway while it balances your trailer's load for a more level ride. Clamp-on brackets require no drilling.I purchased this hitch system at just under $1,000.00 for my 2021 Nissan Titan Pro4X and 2011 Coleman travel trailer. I was experiencing some sway and tailgate sag while towing my trailer with a standard draw bar hitch. This hitch does absolutely nothing to help with sway control even on a 7000 lb 29 foot travel trailer. Less than a year after my purchase a lot of the paint has fallen off and the hitch and adjustable draw bar are covered in rust.
Though the system does help some with the tailgate sag, you have to raise your truck almost off the ground with the tongue Jack prior to setting and tensioning the chains in order to make an appreciable difference. Waste of 18 hours of overtime pay.
Excellent, well built product. Easy to install and use. Makes a difference. Truck went from sagging to normal stance. Pulls the trailer with ease.
Great place to shop. Speedy delivery. Second blue ox hitch. This one is for my son's camper. They are great.
Bulletproof and easy to install. A must have for travel trailers.
Manuel
8/22/2022
Ive had the blue ox a year now, and have gone on 9 trips with my heritage glen 23bhhl. My silverado pulls it with ease and straight as an arrow thanks to this hitch. Once again a must have!!!
Only disappointment was the latch wrench. Previous review (... was impressed that Blue Ox has totally upgraded the chain latch wrench. No longer that flat piece of metal. The new wrench is a plated, heavy duty socket wrench. Much like a wheel lug nut wrench that is made especially for releasing the latches). Apparently the upgraded version of the wrench is hit -or- miss.
Very well made.
Greg
7/18/2022
Very nice. I am very happy with this product . It definitely helps reduce sway. I am more excited about the connection process , very easy.
Easy to follow instructions. Assembly and installation went well. Thanks for the fast delivery and great service.
Made a big differance.!
This was a good hitch and easy to install and easy set up.
Mark
3/2/2022
I have had this hitch for a year now and I still love it. I towed my 31 foot TT from South Carolina to Washington state with my 2016 Nissan NV3500 van. I experienced very little sway, if at all, especially going through the Dakotas, Wyoming and Montana. After having serious sway problems with my previous hitch, I had looked into getting a Hensley type but I didn’t know if it was worth the money. I am so glad I didn’t spend that much because the Blue Ox has been worth every cent and costs much less. It was easy to install and is very easy to hook up and detach from my tow vehicle. I definitely recommend this hitch!
Incredibly fast shipping
Haven’t done a long trip to compare away control. Just installed. Cons first: On an Airstream Globetrotter 25 FBT, it is impossible to get a socket in between the A frame and the battery box to use a torque wrench to measure 40 lbs when tightening the jam bolt. Plus it’s a square bolt head. But it’s only 40 lbs, so we hand tightened hard. Also, when tightening the jam bolt, the chain latch thingy (I’m tired. It’s hot out there!) moved a bit so either hang onto it really well or move it a bit before tightening down and it will move right back to its 29 inch place.
Now the pros: The whole assembly weighs far less than the equalizer we replaced. Installation was easier. No washers so once the hitch head height was determined, we only had to torque once. If we need to adjust weight distribution, we move the chain. My husband compared the two installations like this: “This was junior high math while the equalizer was like college calculus."
And, FWIW, the front and rear end difference in height for our truck and trailer was way more accurate than we could get with the equalizer. Well, maybe we could have, but we would have had to adjust the hitch head and the washers.
The cherry on top was that it was very quiet turning and backing up.
Shipped as promised. Came with everything. Installed per excellent instructions.
Works very well on 21 chevy tahoe towing 6000lb 25 ft travel trailer.
Works as advertised. Havnt been in crosswinds, but trucks passing and meeting, hitch has good control. Load leveling works excellent.
The Blue OX weight distribution hitch is the way to go. With the sway control built in it makes the system more manageable and easy to use. The bars are straight instead of an L for easier storage and the chain tensioner is much easier to load then the typical system that requires going over a high center. I bolted the tensioners to my frame but the standard mount works fine.
I have 2 trailers and had this on a 34 foot travel trailer that weighs 9200 fully loaded. The weight distribution and sway control was subpar at best. My husky centerline rode better and controlled sway and weight distribution. Had to put this on the smaller of our travel trailers because it didn't do the job.
This is a good system, though it can require some tinkering when hitching up. Sometimes it's super easy (connect the bars to the receiver, loop the links to the clamps, and rotate until it clicks into place, done!) while occasionally as the ground varies one bar may resist getting loaded and you have to find a level spot to adjust it. We have found the need to change frequently which link its cranked to. In fact, a couple times I've gone to our standard setting but later had to pull over and crank a couple extra links tighter to keep the sway down. That said, it fit all the criteria for the weight range, frame mount points, etc. and has worked over multiple trips and several hundred miles so far.
I would say the powder coating has been pretty durable, there is a bit of rust developing on the clamps where there's been contact with the chains for one year. But the bars, links, and receiver are looking fine overall.
Overall, it wasn't the first model we had our eye on but it fit the situation and we are fairly happy with how it all turned out.
Bought a 30’ enclosed race car trailer with 1.5’ extra height and pulled it back from Dallas, Tx. with my 3500 DuraMax with no weight distribution hitch! It was not a pleasant drive. I weighted the tongue when I got home and came in at 1650# empty. Got this hitch, BX2000, loaded trailer with car, tools, fuel, generator, and did not re-weight tongue but estimate to be at least 2k. Pulls completely different! Sway is almost nothing. My old trailer was a 50’ goose neck which pulled better but was much heavier and harder for the truck to pull. This hitch will make the difference in a heavy tongue weight bumper pull trailer
This Blue Ox sway control hitch has works well on our trailer. It's heavy, but easy to hook up and use.
My only complaint is with the external finish. The finish on the bars began to flake off almost immediately. Other areas are also showing signs of surface rust.
That said, it does the job it's intended to do, with ease
Have been using this hitch for one year now. We have had zero issues, it is easy to use. Satisfied!
My camper has a c channel frame. Add did not say hitch would not work on c channel frame. hAD TO SPEND $XXX EXTRA
Packaging was terrible! Paint is beat off of it so bad it looks several years old! Missing parts, one lock washer and no hitch pin!
Easy to use and provides the best weight distribution and sway control.
Do you have a question about this Weight Distribution Hitch?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
John
11/13/2023
A year later, its still going strong. I am 64 and it is a very heavy hitch so at some point I will have to find a different solution or stop camping. In some states narcissists have made it illegal to leave a hitch on a truck as theyre too foolish to walk around it. Blame is rampant in those people. Genesis 3, time with Satan while lying about it.