bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Ford RV and Camper Steps


  • What Do Lippert Solidsteps # LC713662 Look Like
  • The Lippert SolidSteps part # LC713662 that you referenced look like the picture that I attached.
    view full answer...

  • How Does Lippert SolidStep part # LC791574 Install
  • I attached a picture that I took from the install instructions for the Lippert SolidStep part # LC791574 that you referenced. Basically as long as you have room for the step assembly they get drilled on with self-tapping screws.
    view full answer...

  • How is Lippert SolidStep Installed on 2018 Keystone Sprinter?
  • The SolidStep Manual Fold-Down Steps # LC791575 will need to install flush against the trailer's sidewall, with the door and door frame removed, which you can see in the photo of the instructions I've included; this would not be done underneath the threshold as it would not be possible to properly screw it in that way.
    view full answer...

  • Can Stow N' Go Scissor Steps be Installed on Camper Without a Bumper
  • While we do not have a video of these steps being specifically installed on your camper I took a look at the instruction manual, which is also linked, and there is a method for installing these steps on a camper that does not have a bumper. You would need to remove your current bracket and it would require a 19.5" x 3.5" mounting area below the door. The mounting bracket for each of these steps is 21-1/2" wide x 8-1/2" deep but its height is going to differ depending on the model you...
    view full answer...

  • Installing SolidStep Manual Fold-Down Steps on Trailer
  • Though I'm not familiar with the strut you are referring to on your 2018 Cyclone, it seems likely you are going to need to relocate it to install the SolidStep Manual Fold-Down Steps # LC791575. If you take a look at the cutout I have added of the installation manual for these steps you can see that the step needs to be mounted flush to the floor and sidewall at the door's opening.
    view full answer...

  • How To Install TorkLift GlowStep Camper Scissor Steps On Northstar Arrow U Camper
  • Since the TorkLift GlowStep Camper Scissor Steps # TLA7803 and TorkLift GlowStep Camper Scissor Steps w/ Landing Gear # TLA7803-8000 you were looking at are designed to be mounted with 6 lag bolts to hold the steps to your bumper, I recommend completing the installation in that fashion. As you mentioned, you very well may be able to install the steps to the two brackets under your bumper as shown in the picture you included, but I cannot confirm that you will not need to modify the steps,...
    view full answer...

  • Solution for RV Step with Bad Gear Box with Part Number 151320
  • The Lippert part number # LC372261 is the part number for an entire replacement step assembly. The problem is that if you have the 151320 gear box that means that your current step is old enough that there aren't replacement parts for it and you'd need a new assembly which the # LC372261 is the closest replacement.
    view full answer...

  • Do The Brophy Camper Scissor Steps Collapse?
  • The Brophy Camper Scissor Steps # AS23 does fold down for storage, so you do not have to leave them fully extended if you don't want to. Simply, remove the arm from the upper bracket, lift the steps up, push the steps down, and secure the, to the keeper located on the back. You can see this being demonstrated in the included video, at the 2:57 minute mark.
    view full answer...