bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Jayco RV and Camper Steps


  • Will Screen Door and Entry Door Close Normally with SolidSteps in Place?
  • When the Lippert # LC791572 steps are properly installed with the threshold plate firmly against the outside threshold you should have no issues. The only thing we hear from customers is how much they love them! While you have your tools out you might as well take down those old stock rattle-trap steps that came stock on your trailer and install the Lippert # LC664640 locking steel box just made to fit in the spot where the steps were. Great spot for black water supplies, or roadside...
    view full answer...

  • How Much Clearance is Needed Between Entry Door and Threshold of RV for MORryde StepAbove
  • The standard clearance requirement for the MORryde StepAbove RV steps like part # MR88RR is 3/8 of an inch which is the same for the # MR28RR.
    view full answer...

  • Difference Between Kwikee 40 Series RV Steps # LC3726892 and # LC3726891
  • There is a slight difference between the # LC3726892 and # LC3726891. The # LC3726892 comes with a control switch setup that allows the light and step to come on and off with the opening and closing of the door.
    view full answer...

  • Comparing Lippert Kwikee 26 Series Electric RV Steps for a 2020 Jayco Greyhawk Motorhome
  • The difference between the Kwikee 26 Series Electric RV Step # LC371136 and # LC3711363 is that the 363 comes the switch kit while the 136 doesn't come with the switch kit. Unfortunately just the frame isn't available so if you have pretty much everything already you'll want to go with the part # LC371136. I confirmed all of this with Lippert. Attached is a review video for you to check out.
    view full answer...

  • Determining if MORryde StepAbove MR78RR Could Fit 2008 Jayco 35LRSA
  • To determine if the MORryde StepAbove part # MR78RR is the correct fit for your 2008 Jayco Designer 35RLSA you'd need to take two measurements. Measure the height of the doorway from the ground and also measure the width of your doorway. If the height is between 34 and 36 inches and the doorway width is between 27-3/4 and 30-1/4 inches the # MR78RR is the correct fit.
    view full answer...

  • Replacement Frame for Kwikee 26 Steps
  • I checked with Lippert and the Kwikee 26 Series step does not have an available frame replacement for it, so you will need to replace the entire step assembly. For a new Kwikee 26 Series Step you'll want to use the # LC3711361, which fits on coaches with a 20-1/2" x 7-1/2" bolt pattern and is an electric step with 1 riser that does not contact the ground. I've linked a review video of this part for you to have a look at, as well.
    view full answer...

  • Are the MORryde StepAbove RV Steps the Second Generation
  • The MORryde StepAbove RV Step part # MR65RR is the same as the STP-210 which is the newest generation. It is designed for a 31-1/2" - 37-1/2" entry height and 27-3/4" - 28-1/4" doorway width. It's a strut assisted model. If you have different measurements please let me know what those are so we can get the correct step or choose from the list below. Please note, the STP-3-30-07h is the older generation no longer made.
    view full answer...

  • Should I Choose The 3 or 4 Step SolidStep For my Jayco Eagle with 29-1/4" Door Way
  • The SolidStep Manual Fold-Down Steps are a great choice for your Jayco 5th Wheel Camper. The amount of steps needed depends on your entry way height from the ground. The SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames part # LC791572 is designed for entry way heights of 27" - 36". While the 4 step SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames part # LC791574 is designed for entry way heights 35" - 44". If you measure from the ground to the bottom...
    view full answer...

  • How to Secure Lippert SolidStep to RV
  • I have added a link to the installation instructions of the Lippert SolidStep Manual Fold-Down Steps like # LC791572 for you to check out. Since you have fiberglass flooring, you'll want to use bolts, as seen in the "B." section of the cut out I added.
    view full answer...

  • Jayco Greyhawk Electric Entry Step Replacement
  • There is only one difference in the Kwikee 26 Series Electric RV Step part # LC3711363 and part # LC371136. The LC3711363 uses the 9510 control and the LC371136 uses the standard control. I am sorry but they are not offered non powered .
    view full answer...

  • What Replacement Steps do I Need for my 2010 Jayco Eagle 351 RLSA
  • It does sounds like from your description that these are the correct replacements for you. The mounting brackets are 27-1/8" wide which matches what you have. There are a few different ways to attach the steps like you said. There are the three top mounting points that will match your front bolt but there are also four on the outside (two front and two rear) that will allow you to attach them to the bracket on your Jayco Eagle. There are also three toward the middle of the back but these...
    view full answer...

  • Dimensions for Hickory Springs Manual Pull-Out Steps # 98224EXTALC1
  • The Hickory Springs Manual Pull-Out Steps # 98224EXTALC1 referenced in your question feature a distance of 14.74 inches from the top of the mounting brackets to the bottom of the assembly when fully open. The mounting base has an overall width of 27.50 inches with a 9 inch drop/rise between the steps. I have attached an image with these and other dimensions labeled for this particular assembly that you can check out as well. You can also use Outriggers like # LC301704 to install new...
    view full answer...

  • Key Dimensions for Selecting Replacement Triple Step Unit for Jayco Travel Trailer
  • Your photo did not make it through to us but we can still help you select replacement steps for your Jayco Jay Flight 28BHStravel trailer. The RV steps we offer for towable trailers come in several overall widths. You can see all sizes and models on the page I linked for you. You will want to match the overall mounting pattern of the new step to your existing unit. You will also want to ensure the new step unit does not reduce your ground clearance; keep the existing step's retracted...
    view full answer...

  • Will Manual Pull-Out Steps # LC432690 Fit 2008 Jayco Jay Flight 30 BHS
  • Yes, the Manual Pull-Out Steps # LC432690 that you referenced will fit your 2008 Jayco JayFlight 30 BHS. The great thing about RV steps is that they can basically fit any RV since the install brackets can be moved, the steps can be welded directly to the RV, or you can install new brackets with the Outriggers # LC301704.
    view full answer...

  • Which Torklift Glowstep Fits 2017 Jayco 29RKS
  • Since the height from the ground to the doorway on your Jayco Model 29RKS is 34 inches the Torklift GlowStep Revolution part # TLA8004 that you referenced is the correct step to go with. This step has a height range of between 32-1/2 and 44 inches. I attached an install video link for these steps on a very similar 2015 Jayco Pinnacle for you to check out as well.
    view full answer...

  • Lippert SolidStep Manual Fold-Down Step Compatibility With A 2019 Jayco Hummingbird Travel Trailer
  • Since you'll have to factor the door thickness into the entry width you'll want to measure how far it sticks out while opened. The SolidStep Manual Fold-Down Steps for 24" Wide RV Door Frames # LC713662 are approximately 20 inches wide so you'd have about four inches of clearance and can slide it further towards the opposite side of the door frame from the door to ensure it clears the door.
    view full answer...

  • Recommended SolidStep for 2016 Jayco Jay Flight Travel Trailer
  • Because of your concerns with your wife's ability to make a larger first step, I suggest you go with the third step option of the SolidStep, # LC791572. This triple step is designed to fit 25" to 28-7/8" wide doorways as measured from flange-to-flange and an entry height of 27"-36" from ground to the threshold. This will of course put that first step right down to ground level with little rise; legs adjust in 1" increments A valuable addition to the SolidStep is the, Lippert Entry Assist...
    view full answer...

  • Replacement Kwikee Electric Steps for a 2005 Jayco Greyhawk 31SS
  • There are and were numerous 2-step Kwikee electric steps available. To ensure we get you the correct replacement I would need to know the series of the steps you have. Check the underside of your steps for any model numbers or other information. The current available models are the 32 Series # LC372261, 42 Series # LC372779, 40 Series # LC3726892, 34 Series # LC3722863, and Platinum Series # LC372558. Any information you can find on your steps will help narrow it down.
    view full answer...

  • Replacement 3-Step Pull-Out Steps for Jayco White Hawk Travel Trailer
  • There should hopefully be a model number or manufacturer information somewhere on your step assembly. This would typically be printed on a sticker on the underside of the steps or brackets. If you can't find any identifiable information, you can also choose a compatible replacement based on the measurements for your existing assembly. You will want to make sure the mounting bracket features the same dimensions for easy installation. The closest Lippert 3-step assembly we have to...
    view full answer...

  • Troubleshooting Kwikee Step Series 32 Steps That Won't Retract
  • It sounds like there is an issue with your linkage assembly that is causing the gears and motors to stop. I recommend using the Lippert Components Kwikee Step Gear/Linkage with A (1101425) # LC379160.
    view full answer...

  • Replacement Steps for Jayco Jay Feather 23BHM
  • I recommend the TorkLift GlowStep Revolution # TLA8103 . This is a 3 step set with an 8" drop/rise that have an easy-to-use lever that lets you change between 3 height settings for proper elevation and will work for trailer entry heights of 25-1/2" - 36" tall. I really like that there is Glow tape on the steps to create a lighted step surface for safely climbing into and out of your camper at night. The mounting plate dimensions for these steps are 25-1/2" wide x 13-7/8" deep so you'll...
    view full answer...

  • Lippert SolidStep 4-Step Assembly for 29-1/2 Inch Wide Doorway
  • I spoke with my contact at Lippert and he said that for your 29-1/2 inch wide doorway on your Jayco 5th Wheel the SolidStep Manual Fold-Down Steps # LC791574 will work perfectly. This assembly is designed for trailer/RV doorways that measure 26 to 29-7/8 inches wide and will lock in place and stow inside when not in use. I have attached a short video demonstration that you can also check out.
    view full answer...

  • Fold Down RV Quad Step that Could Fit 23 inch Wide Door
  • The closest option that might work is the MORryde StepAbove Strut Assist Fold-Down Step for 23-3/4" - 24-1/4" # MR75RR but since you are technically 1/2 inch too narrow you might have to look into a slightly wider door frame. This will work great with your threshold height of 40 inches as well. Lippert does not have a SolidStep in the quad step design that come close due to your doorway width.
    view full answer...

  • Replacing Kwikee 32 Series Steps on an RV
  • The easiest replacement solution will be a new set of the Kwikee 32 steps you have part # LC372261 which will bolt right up. It's pretty rare these get damaged so I would not anticipate the same problem you had. You would need outriggers # LC301704 to install manual steps like # LC432682 but it's going to be a bit more involved as you'll have to most likely weld the outriggers to the frame and then bolt the steps to them.
    view full answer...

  • Which Lipper Solid Steps for 2021 Jayco Rocky Mountain Edition Baja with 25-1/2" Wide Entry Door
  • You've found the correct Solid Step! When measuring to find the correct Lippert Solid Step you'll want to take your door width measurement and round up to the nearest 1", so your 25-1/2" door entry width will mean you want the Solid Step Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames # LC791574. This unit is designed for entry heights between 35" and 44", so it will work perfectly for you. I've linked a short review video of these steps in case you haven't already checked that out.
    view full answer...

  • How to Determine if Lippert Steps LC432682 Will Mount to Existing Brackets
  • Though you will want to verify, if you have the exact same system then there should not be an issue using your existing brackets to mount the Lippert Manual Pull-Out Step for RVs - Double - 7" Drop - 24-1/4" Wide # LC432682. To verify if the # LC432682 will mount to your brackets, you'll need to measure yours to determine if they are the same; the measurement should be 25-1/2" wide x 9-3/4" tall x 12" deep.
    view full answer...