Since the distance from your threshold to the ground is 38", and the narrowest part of your door is 28-1/4" side-to-side, the MORryde steps that are a fit for you are the MORryde # MR28RR steps featuring 8" deep steps.
Optionally you could also use the MORryde # MR85RR steps which are the same as the MR28RR's except they feature gas lift struts that allow you to lift of lower the steps with one finger!
If these steps are replacing traditional fold in steps you should consider the... view full answer...
For your 2021 Keystone Passport SL Travel Trailer with an entry height of 32" and door width of 24", yes, the correct SolidStep Manual Fold-Down Steps is option, # LC698799. Currently these are not in stock. However, I do have a couple of viable alternatives to suggest. The MORryde StepAbove RV Steps, # MR98RR is for 23-3/4" to 26-1/4" wide doorways and entry height of 32"-33". There is also the Strut Assist version of this model step in, # MR45RR. Plus an additional option of the Handrail... view full answer...
If you currently have the Triple Step, SolidStep Manual Fold-Down Steps for 25" to 28-7/8" RV Door Frames, # LC791572 and prefer a quad step, I suggest part number # LC791574. This is the same SolidStep for 25" to 28-7/8" RV door frames but in a quad configuration and will mount exactly the same your current install. view full answer...
If I'm understanding you correctly, the MORryde StepAbove RV Steps # MR68RR is 8.3" deep when in the upright position.
Based off of the measurements you took of your 2007 Keystone Montana 2955RL, the MORryde StepAbove RV Steps # MR68RR should work great for you. view full answer...
Yes, TorkLift GlowStep Revolution Scissor Steps Item # TLA8003 is the correct steps for the measurements you provided to replace the steps on your 2016 Keystone Cougar Fifth Wheel. I do recommend, if you have pets, to add the SafeStep Vinyl Barrier Item # TLA7602. K9s have a hard time not looking through the steps as they walk up into the camper and get scared they are going to fall through. Adding the barrier provides a wall so they can see there is a back to it.
view full answer...
Thanks so much for the photos they were super helpful, and based on those we do have the exact Lippert SolidSteps you need. Since your doorway width is just over 25 inches and entry height is just over 34 inches the correct SolidStep is the following:
- SolidStep Manual Fold-Down Steps # LC791572
These steps will fit doors with your width and entry height, though the stabilizer you are referring to will likely need to be removed as it juts out too far. I have added links to the instructions... view full answer...
For your 2011 Keystone Springdale 295 with a 24" wide door and 32" tall entry height I recommend the MORryde StepAbove Fold-Down Steps for 23-3/4" to 26-1/4" RV Door Frames - 8" Drop # MR98RR which will fit perfectly and contacts the ground to make the step more stable and easier to use.
I included a video of the # MR98RR for you to take a look at. view full answer...
We have a wide selection of steps available so I am certain that we can locate a suitable replacement step for you. While I can not provide you with an exact part number for your current steps installed by the builder of your 2014 Keystone Cougar Half-Ton Fifth Wheel, I can locate options. From what is available to me online I suggest the Alumi-Tread Manual Pull-Out Step with 9" Drop/Rise at 24" width, # LC432696. They measure 24" wide for the step but the overall width is 27-1/2" please... view full answer...
The SolidStep Manual Fold-Down Steps # LC791572 is exactly what you are looking for! It is a triple step that fits 24" - 26" Wide RV Door Frames and comes with the 1-year limited warranty. view full answer...
Thank you for the dimensions of your current steps on your Keystone Springdale SG 27i and yes the Alumi-Tread Manual Pull-Out Step for RVs # LC432696 does fit. view full answer...
The Lippert Alumi-Tread Manual Pull-Out Step - Quad # LC432698 that you referenced does indeed feature a drop/rise of 8 inches, while the Lippert Alumi-Tread - Triple # LC432696 has a drop/rise of almost 9 inchces (8-3/4 inches to be exact).
The 4-Step model will feature an overall distance of 49-5/8 inches from the top of the mounting bracket to the bottom of the last step. The 3-Step model has a distance of 38-3/4 inches for this measurement. The ideal entry height for the 4-Step,... view full answer...
Most RV steps are going to have a drop/rise of about 8". The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear, # TLA8003, has a drop/rise of 7-1/2" when fully extended. For a four step, # TLA7834. Or a 5 step, # TLA8005. These come in a few different widths as well.
Please see the link attached. view full answer...
Which RV step you need depends on the size of your trailer door opening.
The Lippert SolidStep, Item # LC791572, is a 3-step model for RV doorways that are 26" to 29-7/8" wide. It has a threshold height of 27 inches to 36 inches from the ground.
I tried to find details on your 2016 Keystone Bullet but could not find exact measurements. There also is a variety of sizes possible so "one size" does not fit all. Fortunately, Lippert makes 90-percent of trailer frames and several... view full answer...
The correct SolidStep Manual Fold-Down Steps for your 2018 Keystone Sprinter Limited are going to be part # LC791575. According to Lippert, you simply need to measure your doorway and then round up to the nearest even number which in your case is 30. The above is designed for a threshold from 35" - 44" so I can confirm this is correct for you. view full answer...
The triple step Lippert Solidstep you want is the part # LC698799 as this step has a width range of 24" - 26" wide for the doorway which is perfect for what you have. view full answer...
For the Lippert SolidSteps you would want to go by the narrowest width measurement at the door opening. For you that seems to be 24-1/4 inches so your best option is # LC698799. Like you said, the SolidFold steps come in an 8 inch rise, so any modification to get to 6 inches would void the warranty as you mentioned. view full answer...
Sounds like the outriggers are what you need to replace. For that we have the # LC301704 which we recommend when people are installing new trailer steps. view full answer...
We have just what you need with the MORryde StepAbove RV Steps # MR98RR. These steps fit a door width of 23-3/4" - 26-1/4" and an entry height of 30" - 33-1/2".
These steps have a simple twist handle to unlatch and fold down the steps. There are pull pins in the hinge of these steps to allow you to remove the steps when in close quarters that won't allow for the steps to fold down. I will say having tested these out that the pull pins are in pretty tight and might be a bit of a challenge... view full answer...
The Lippert Alumi-Tread Manual Pull-Out Steps # LC432698 referenced in your question may work well on your 2017 Keystone Montana High Country. In order to verify that they will install perfectly in place of your existing assembly you will just need to take a couple of measurements. Trailer manufacturers do not typically do a good job of maintaining detailed specs on items like these so I was unable to verify the type and size of the assembly that is currently installed on your Keystone... view full answer...
As you have identified, the entry height of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear, # TLA8003 for three steps, and # TLA8004 for four steps, overlap in their application specs. The # TLA8003 is for entry height of 25-1/2" - 36" with # TLA8004 for 32-1/2" - 44". Please note that each of theses options has independently adjustable landing gear on the bottom step. These feet will adjust a full 3" for height and there is also a low, medium and high point setting for... view full answer...
The MORryde StepAbove RV Steps with Strut Assist, # MR45RR is for trailers with a doorway width of 23-3/4" to 24-1/4". This is a 3 step version for entry door heights of 31-1/2" - 37-1/2". view full answer...
The TorkLift GlowStep Revolution # TLA8003 measures 7-1/2" between steps and yes, they are consistently all the same. The only way they would not be is if you adjusted the landing gear on the bottom, which you can do to ensure they are perfectly stable on any terrain. view full answer...
The SolidStep Manual Fold-Down Steps part # LC791572 for triple and part # LC791574 for quad will both fit and work on level ground. That said, if you find yourself parking on uneven terrain then you'd need more of a buffer which the triple step would provide so that is what I recommend. In regards to the space between the ground and first step, this would vary each time depending on the incline or slope you are parked on so it's not a figure I can provide but it's really a matter of choosing... view full answer...
I do have an option for you but there isn't an add-on kit for the MORryde StepAbove RV Steps, you will instead need to replace the steps for a model with this feature built-in like the MORryde StepAbove RV Steps with Strut Assist part # MR45RR.
Unfortunately, I am not able to know what steps you have or need for your trailer so you'll need to provide me with the model number of the ones you have or the entry width and threshold height. I have attached all options below. view full answer...
We have just what you need. The SolidStep Manual Fold-Down Steps # LC678027 that you referenced are a 4 step version of the SolidStep designed to fit up to 30 inch wide doorways like you have. view full answer...
The Torklift GlowSteps part # TLA8004 is the kit you need since you said your doorway to ground measurement is 36 inches. This has a height range of 32-1/2" - 44" so your height of 36 inches falls perfectly in that.
The landing gear doesn't have to be removed/installed everytime it's used so you wouldn't have to worry about extra steps involving them when going in and out of the RV. Basically they pull out and you are set.
If you check out the 1:30 mark of the video I attached to... view full answer...
We haven't fit the SolidStep Manual Fold-Down Steps, # LC791573 specifically to a 2010 Montana. However, if you let me know the dimensions of the well step, how wide your door frame is and how high your threshold sits off of the ground, I can help you find the correct SolidStep for your application.
Measure between the door frame flanges for threshold width, and measure from the mounting point to the ground for the entry height. view full answer...
The SolidStep Manual Fold-Down Steps # LC791574 that you referenced have a travel/stored position height of 56-1/4 inches which would be the distance the steps would swing out from the RV when raising and lowering. view full answer...
Typically in this situation you'll either have to move the strut further up on the door clear of the SolidStep Manual Fold-Down Steps for 25" to 28-7/8" RV Door Frames - Quad - Aluminum # LC791574 or use a door stop like the Plastic Stem and Rubber Socket Door Holder - 2" Long Stem # DH39R to create a bumper between the door and exterior wall. view full answer...
As long as your 2005 Cougar 254 5th wheel trailer has a door width no smaller than 26" and your threshold height is in the range of 27" - 36" from the ground then the SolidStep Manual Fold-Down Steps # LC791572 is a great solution for you! If your 5th wheel doesn't fall in either of the specs listed above let me know what you have and I can help you choose the correct steps. view full answer...
Great questions.
I have solutions for both questions.
Lippert does not sell replacement bolts or hardware kits for this application you will be able to source the bolts you need from any local hardware store.
As for a replacement options I strongly recommend the MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways - 3 Steps # MR98RR. They are a solid step that offers great stability. No more worries if your steps are going snap off and cause a fall.
You just need... view full answer...
These are great steps, no negative concerns with the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear. However, # TLA8004 that you linked to is designed for an entry height of 32-1/2" - 44". If you have an entry height of 28", then I suggest the # TLA8003 model. This is for an entry height of 25-1/2" - 36".
view full answer...
The SolidStep Manual Fold-Down Steps, # LC791572 is a three step version for an entry height of 27" to 36" and a door width of 25" to 28-7/8".
The # LC791574 is the four step version that has the same door width of 25" to 28-7/8" but is for an entry height of 35" to 44". I have listed each due to your entry height being listed at 36" and suggest the four step version, # LC791574 so that you have max availability of the adjustment options for the legs. Please note the product review... view full answer...
Yes, you have the correct step for your 2018 Keystone Cougar Fifth Wheel. If your door measurement from flange to flange (the narrowest measurements of the doorway) is 28-1/4" with your threshold at 40-1/8" from ground, then the SolidStep Manual Fold-Down Steps, # LC791574 is the correct part number. view full answer...
Go To Results