bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Winnebago RV and Camper Steps


  • Do MORryde StepAbove RV Steps MR26RR Fit 24 Inch Wide Doorway
  • The doorway width - the width from flange to flange of your doorway - needs to be between 23-3/4 inches and 26-1/4 inches, so yes, your 24 inch door will allow you to use the MORryde steps you asked about, which are the following part number: - MORryde StepAbove RV Steps - 2 Steps # MR26RR The only other thing you need to be sure of is the entry height (which is measured from the doorway threshold on your camper to the ground), as the # MR26RR is for entry heights measuring from 25...
    view full answer...

  • What is the Difference Between Kwikee Steps # LC3747453 and # LC3747452
  • The difference is that the part # LC3747453 comes with the Adapter/Harness # LC369413 and the Switch Magnet # LC369299 while part # LC3747452 does not. Aside from that these are the same step.
    view full answer...

  • What is the Height of the Retracted TorkLift Glow Step Revolution
  • The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear # TLA8102 have a height of 16-1/2" from the top of the mounting bracket to the bottom of the steps when fully retracted. I've attached a photo of this to give you a visual.
    view full answer...

  • Replacement Pull Out Step for 2001 Winnebago Minnie Winnie 22R
  • I looked up pictures of your 2001 Winnebago Minnie Winnie 22R and it has a cut out for a single step below the door. The Flexco Manual Pull Out step part # SMFP-1100 was designed to fit RV setups just like yours but you'd want to measure first to know for sure. Worst case scenario you'd have to move the mounting brackets or use outriggers like part # LC301704. The width of the mounting brackets of this are 25 inches though. Another option would be to weld these in place to your frame.
    view full answer...

  • Replacement Three Step for 2021 Winnebago Micro Minnie 1808 FBS
  • I looked up some pictures of your 2021 Winnebago Micro Minnie 1808 FBS and it has an Alumi-Tread pull out step so for a three step version you'd need the part # LC432696 and you'd be set.
    view full answer...

  • Is a Replacement Gear Box for Kwikee Step with Gear Box 151320 Available
  • The 151320 gear box is for a Kwikee step, but unfortunately that model gear box is no longer available as a replacement part. Because of this, your only option at this point is to replace the steps entirely. If you had a Kwikee 32 Series step you would need Lippert Kwikee 32 Series Electric Step # LC372261, for example. If you let me know what steps you have I would be happy to help you find a replacement.
    view full answer...

  • Installing Flexco Manual Pull-Out Steps On A 2021 Winnebago Micro Minnie 1808FBS
  • The Flexco Manual Pull-Out Steps for RVs # SMFP-2100 were designed to fit a 26" mounting bracket width so if your older steps were a little big larger or wider you can definitely use the Lippert Outriggers for Manual and Electric RV Steps # LC301704 to help match these steps to your mounting plate bolt pattern.
    view full answer...

  • Solution for Non-Folding 2-Step Replacement Steps For 2018 Winnebago Minnie
  • Since you can't fold in the steps on your 2018 Winnebago Minnie I recommend the MORryde Quick Connect RV Steps for 21-1/2" to 27-1/2" Entry Height - 2 Steps # MR73RR. The mounting bracket for these steps attaches on the outside below your door. Since they are removable they can still be stored to keep them protected just like fold in steps. They are also adjustable so they will remain sturdy even on uneven land. These steps are designed for an entry height of 21-1/2" to 27-1/2".
    view full answer...

  • How Do You Mount The TorkLift GlowStep Stow N' Go Scissor Steps
  • Nice question, lets find out below: First we need to make sure that you have the right fit. Measure from the ground up to the door frame and then measure the width. **TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 3 Steps - 375 lbs - Black Bracket # TLA7833. This unit listed above fits entry heights 23-1/2 to 34-1/4 inches tall. The mounting bracket needs an area right under the entry door that is 21-1/2" wide x 12-1/2" tall x 8-1/2. Here is a list of the basic...
    view full answer...

  • 2-Step Electric Step Assembly for 1986 Winnebago Chieftain 27 Motorhome
  • We offer a range of 2-step electric step assemblies for motorhomes like your 1986 Winnebago Chieftain 27 that are displayed on the linked page. These are available in three different widths: 24-inch, 26-1/4-inch and 30-inch. Based on photos of this motorhome that I found and reviewed I think your step size will be 24-inches like # LC372261. The mounting holes for this unit are spaced apart 8 x 22-inches. All step units are rated for 300-lbs. You will want to take note of the spacing...
    view full answer...

  • Could 3-Step Alumitread Lippert Steps Replace 2-Step
  • It is pretty common for the 3 step RV steps to be a couple inches wider than the 2 step options so I would not be shocked if the width of the Lippert steps # LC432696 being 27-1/2 inches is wider than what you have now. As long as you have the width needed for these to fit they would still work. The brackets probably won't bolt right up so you could use the outriggers # LC301704 for new ones.
    view full answer...

  • Replacement for Kwikee 40 Series Steps on RV
  • The Kwikee Electric RV Step Complete Assembly part # LC3726892 would be a excellent replacement option for the Kwikee 40 Series Steps. It comes with everything you need for a new install such as the step assembly, door magnet, switch, controller, and motor.
    view full answer...

  • Can Single Step of Winnebago Access Chalet Be Replaced by Double Step
  • A double step can replace a single step but typically the widths are different. Worse case scenario you can move the brackets or install new outrigger brackets but it's very doable. Do you know what the width of your current steps is? A very common double step is the part # LC432682 which is 25-1/4 inches wide which is a very common width. For outriggers then you'd want the part # LC301704 if your current brackets aren't the correct dimension
    view full answer...

  • Which RV 2-Step Would Work Best for 27-1/8 inch Wide Bold Pattern
  • The closest RV 2-step to what you listed would be the Torklift GlowStep part # TLA8002 which is overall 27-1/2 inches wide. The other pull out options we have are much narrower.
    view full answer...

  • How To Choose Correct Electric 2-Step Replacement for RV
  • In order to confirm the correct replacement electric step assembly for an RV you'll need to know the step make, model number, and series. The most common are Kwikee Steps which are offered in 32 Series, 27 Series, etc. Once this is obtained, you can then choose the correct one using the list attached below. The width of the mounting bracket can also be used as a filter to narrow down options. The Kwikee Electric RV Step Complete Assembly part # LC372261 is our most popular replacement option.
    view full answer...

  • Replacement for Kwikee Revolution Step 9010000464 on 2011 Winnebago Journey 40U
  • According to Lippert, the correct replacement for your 9010000464 model Kwikee Revolution Steps is the Replacement Steps, Motor, and Control for Kwikee RV Electric Steps - Revolution Series # LC3725791. If you want the complete assembly with the override switch you will also need the # LC369311.
    view full answer...