In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Hey Eric, I recommend going with the Bulldog Winch Trailer Winch #BDW66FR. This winch has a static line load of 9,800 lbs, has a line speed of 29 FPM, and has a free spooling clutch with a 360 degree gearbox that can be rotated so you can reach the…
For a 12,000 lb. electric car trailer winch like the Bulldog Winch Trailer Winch part #BDW10040, I recommend a standard 12 volt lead acid battery rated up to at least 650 cold cranking amps (CCA). As long as the battery is rated up to 650 CCA then…
Hi Walter, For the Deka Battery Isolator #DW08770 you can go with 8 gauge wire. Deka actually makes an installation kit with this wire, the Deka Battery Isolator Installation Kit for Standard Alternators #DW08769.
It is plastic. The ComeUp UW-5000si Trailer Winch item #CU645010 is a light duty winch so it's housing and base are made of plastic. I attached a picture below that will show you the base.…
Since you've already got a 4 pole on your trailer, you'd just need to add a 7-way with #ETBC7 so that you can run a charge line using #10-1-1 from the accessory circuit to your battery. This…
A diode like the part #RM-690 is a great idea but the only issue is that is has a max load of 85 amps. A standard 5,000 lb winch, like the ComeUp DV-5000si #CU645010, will greatly exceed the 85 amp rating of the diode so it would be useless. What…
If you're going to use a winch to raise and lower your popup you will want a winch that power loads both in and out. With a winch that will only power load in you will only be able to raise the popup and not lower with…
If I'm understanding you correctly the starter solenoid #PK5231201 is not the solution to your problem. Based on what you have described, it sounds like both the breakaway battery and winch battery are hooked to the 12V…
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
The LT3000 winch, #SW1130220, is a good choice for pulling a 2,350 pound vehicle onto your trailer. With a rolling load (your vehicle) on a 17 degree slope (typical range for a trailer ramp) the winch will have a 7,825 pound rolling load capacity.…
Hey Tim, Good questions, and camper tie-downs are always a touch confusing so I can explain the difference for you between the two TorkLift camper tie-downs for your 2016 Ford F-250 long bed with factory hitch and no running boards. The difference…
Hey Galiano, so Torklift makes the best frame mounted camper tie downs but since they fits are very specific what you'll want to do is follow the attached link to see all of the available options where you will need to…
(6)
(3)
Filter Results
