Filter by Product Type
$19.36 - $236.36
Videos
for Lubricants Sealants Adhesives
Help Articles
for Lubricants Sealants Adhesives
Expert Answers
for Lubricants Sealants Adhesives
Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
view full answer...You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…
view full answer...EZ Lube axles like the item #T3584F-EZ-8974 come from the factory with just a little bit of grease in the bearings. The first time you use the EZ Lube feature to fill the axle, it will take a lot of grease. You will probably use 3/4 to a full tube…
view full answer...Hello Brian; the 3/8" difference isn't enough to matter so you can use the #e89FV as a replacement. We do have the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb Round Trailer Axles #APUBR-8 for 3" diameter axles. This has 7" long…
view full answer...I recommend the LubriMatic LMX Industrial Strength Grease #L11390 for your Dexter axle on your 2021 Vista Cruiser Travel Trailer. This grease is specifically formulated to work in extreme hot and cold temperatures under high pressures. It is also…
view full answer...We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…
view full answer...Hey Roland, thanks for reaching out! Overslung axles are a special order situation and we unfortunately only have standard axles here at etrailer. With that being said, you can order a standard axle that meets your specs and then use the Dexter…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…
view full answer...Hey Jeff, based on your axle info the correct bearing kit would be the part #BK3-310 for a kit that includes both bearings #LM67048 and #25580 as well as a grease seal. This would be all that you'd need as you can reuse the dust cover.
view full answer...You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…
view full answer...The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit #TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.
view full answer...