Filter Products
Filter by Monitors
$1,167.00 - $2,650.00
$329.00 - $2,650.00
$329.00 - $2,650.00
$329.00 - $2,650.00
$1,167.00 - $2,650.00
$1,699.00 - $2,650.00
$201.97 - $2,650.00
$201.97 - $2,650.00
Videos
for Smart RV
Help Articles
for Smart RV
Expert Answers
for Smart RV
Based on my research, the Dexter Trailer Hub and Drum Assembly #8-201-5 will replace the 3160121 drums on your 2003 Airstream Classic. This assembly is designed for 5,200 pound axles and features a 6 on 5-1/2 inch bolt pattern. I have attached an…
view full answer...When this has come up before, ThermaHeat recommends removing a portion (18-1/4 x 12 in this instance) of the insulation on the tank large enough to install the #277-000164 heater so it's in direct contact with the tank. You're correct,…
view full answer...Hey Korey, That's a totally normal installation for the RV Holding Tank Heater #372HTH-A. My only word of advice would be to run a dedicated outlet for it to plug into with a switch somewhere in-line that's easy to access so you can cut power…
view full answer...Hello Eric. For the SeeLeveL Sensor for RV Holding Tank Monitor #SE78VR, the blue wire is for the tank sender signal and the black is for ground. As long as they are wired correctly, they will work with any monitor including your ESP8266.
view full answer...Thanks for the picture and info on your current brake assemblies, from that we know that the Dexter brake assembly part #23-106 that you referenced is the correct fit. For the left hand side you'd then want the part #23-105.
view full answer...Hey thanks for reaching out, Rick. We do have a PDF of the instructions for the SeeLeveL RV Holding Tank Monitoring System #SE99VR. You will find a link to the instruction below in the "featured help information" section. The installation…
view full answer...I spoke with my contact at SMI and the piece you are looking for is #SM99625 which is the fitting and the bracket. Or if the bracket is still fine and all you need is the fitting you just need the part #SM99726.
view full answer...The SeeLevel systems will require you to replace your current monitor in order to properly read the sensors and operate. There are quite a few different combinations of monitors and sensor strips so I'd like to know exactly what you're…
view full answer...I do have an option to help prevent sag in your rear suspension when towing your trailer that does not include a weight distribution system for your 2021 Volkswagen Atlas. The option I recommend is adding the Firestone Coil-Rite Air Helper Springs…
view full answer...No, the SeeLeveL RV Holding Tank Monitor #SE84VR does not include the sensors. The sensors are sold separately. - SeeLeveL Sensor for RV Holding Tank Monitor #SE78VR (12") - SeeLeveL Sensor for RV Holding Tank Monitor #SE27VR (16")
view full answer...You are going to need a different monitoring panel for the SeeLeveL sensors since your current probe style sensors like the #T21301VP are only going to show open and close readings since each tank will have multiple sensors. You will want to use the…
view full answer...We have the 710-AR and 710-ES2 SeeLevel sensors, though I was unable to find any 701AR or 701ES2. If you were referring to the 710-AR and 710-ES2 you would need the following: - 710-AR: SeeLeveL Sensor #SE88VR - 710-ES2: SeeLeveL Sensor #SE78VR
view full answer...