1. Trailer Parts
2. Trailer Door Parts
3. Side Lip Sealsx

Hey Scott you will need to get the width of your ramp as well as the weight of the ramp to pick out what you'd need. For example the part #M394FR is for 8 foot wide ramps and has a weight…

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when…

The 120-LB #M354FR is going to likely be a better option with the door weight between 125-130lbs. While the 150-LB #362SA8207 will work the higher weight will make the door want to raise up off the ground which can be troublesome when trying to…

Hey Doug, thanks for reaching out! The T-Strap Hinge for Enclosed Trailers #PLR3408 doesn't have a weight capacity. We've reached out to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

We have weatherstripping tape that can be used to seal your bed bunk doors withe part #WS1434 which is 3/4 inch wide that is 50 foot long or the part #WS1412 which is 1/2 inch wide and 45 inches long.

Good morning, James. The total length of the Dexter DX7.5L A-60 Brake Actuator #DX29FR is 19". I made a diagram for you which I have included below.

Thanks for the photos, Audrey! To replace your lower trim we have a few different options, and the correct one just depends on how much of that trim is on the underside of your trailer: -…

Unfortunately, Hollywood Racks doesn't have a rack that has an integrated ramp that's also rated for 5th wheels. So instead, I recommend…

We do have a bunch of seals available for you, however to find out exactly what you need for your RV, you'll need to cut a section off of your existing seal, and measure the width and height,…

If you already have a seal that you're replacing then you want to get a seal that's a similar size, otherwise if…