2016 Ford F-350 Super Duty Grille

The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV will be just fine if you need to lift your 2022 Ford F-250 Super Duty, but it will be good practice to lower the psi rating to 5 prior to lifting the truck. I confirmed this…

The BAKFlip MX4 Tonneau Cover #BAK48330 for the 2022 F-250 short bed has 4 panels. While you are using your Demco Autoslide 5th Wheel Hitch #DM8550024 you will be able to keep one panel laying flat on the bed. There are tow ways you can store the…

When you say "Bike started to come off the back of the trailer" does that mean that you are using the T2 Pro XTR #TH69TX on the back of a trailer? If so then that could be the problem. The issue is that there is…

Yes, the Firestone Ride-Rite Air Helper Springs #F35FV are compatible with your 2022 Ford F-250 4x4 with factory 5th wheel prep package. This system is compatible with in bed hitches, so it will be a great choice for your truck. I also recommend…

We do have tonneau covers that will be better when hauling a 5th wheel. Folding covers are not the best option because when folded up it sits above the bed rails quite a bit. This could result in damage to your trailer, the tonneau and your 2019…

Since you are pulling a trailer that weighs around 8,500 lbs. you would just want to stick with the Firestone Ride-Rite Air Helper Springs #F35FV (5,000 lb.). You really only need to spend more for the Firestone Ride-Rite Red Label Extreme Duty Air…

The head of the Demco Hijacker part #DM8550024 weighs 65 lbs. The total weight of the hitch with the head would be 289 lbs. You would need two people to get this hitch in and out.

The total weight of the Demco Hijacker Autoslide 5th Wheel Hitch #DM8550024 that you referenced is 289 lbs. It comes apart in a few pieces pretty easily to make assembly and disassembly easier.

The pin weight of a 5th wheel trailer will usually be around 20% of the trailer's gross trailer weight (GTW) rating. The only real way to find the loaded pin weight of your 5th wheel trailer would require access to a commercial…

When adjusting the arms of the #BWRVK3305, you have the option of setting up so the king pin will sit 3 inches forward or 1 inch forward of the axle. I'd set it up at the tallest height, 18-3/4 inches above the floor of the truck bed…

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

You're going to want to go with the set of Timbrens item #TABSTOR4R you were looking at. The only SumoSprings available for the 4WD 2002 Toyota 4Runner are for the front end item #SS84PV. The Timbren Active Off-Road Bumpstops item…