Thanks for reaching out, Zack! According to my research the Roadmaster Front Anti-Sway Bar #RM-1209-136 will fit the Freightliner XC chassis that your 2006 Damon Astoria Pacific Edition motorhome has. We unfortunately don't have a rear…
The #DX39FR Replacement Inner Member for Dexter DX7.5L Actuator - Single Axle w/ Disc - 2" Ball is what you need. This is the replacement inner member for Dexter DX7.5L and Legacy UFP Brake Actuators like your UFP A-60 so it would be exactly…
The Replacement Inner Member for Dexter DX7.5L Actuator #DX39FR is the correct replacement for Dexter DX7.5L and Legacy UFP Brake Actuators which includes your Tie Down 75LP. The two wires are connected to the reverse lock-out solenoid, one of the…
I can help you pick out the correct hub, but we don't have a cross-reference part number for the one you listed. In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first…
In order to choose the correct ball mount for your tow vehicle and trailer, you will first need to take a couple of measurements. With your tow vehicle parked on level ground, take a measurement from the ground to the top of the trailer hitch…
Exactly! Both hitches are very similar in design and construction. That is usually what happens when hitches are custom-fit for your vehicle. The main difference is the finish. I personally prefer the matte finish that #e98839 has. We have them on…
The distance between the center of the ball hole and the hitch pin hole of the Convert-A-Ball Dual-Cushioned, Adjustable Ball Mount #CAB-UM is 11 inches.
Although your photo did not come through, I believe I was able to get the measurement you were wanting, which is the distance from the center of the hitch pin holes to the back of the closest part of the B&W Tow & Stow 2-Ball Mount - 2"…
We offer an Extra Long Ball Mount, #D-28, which has a 4 inch rise and a 6 inch drop. The distance from the center of the pin hole to the center of the ball hole is 14-1/4 inches. In order to maintain the structural integrity of the ball mount, making…
I went out to our warehouse to measure the distance from the center of the hitch pin hole to the back of the shank on the Curt Class II Drawbar, #C45521, and it is 1-1/2 inches. I have attached a picture to illustrate my measurement.
I see the confusion with the hole spacing and think I can clear it up. The holes are 3/4 inch and they are 2-1/2 inches apart on center. They are not 1-1/4 inches apart however, that is the adjustment increment based on the Convert-A-Ball Cushioned…
You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…
What our customers are saying:
"This site is top notch: Great prices, great service. Highly recommended."