Since you want the red and amber lenses to match up correctly the better choice for you would be the Wesbar LED Agricultural Light with Brake Light #W54209-021 for the passenger side and then the #W54209-007 for the driver side.
Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…
Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…
So the Custer Reflective Slow Moving Sign #EMB20GM attaches to the Custer Slow Moving Vehicle Mount Kit Spade Item #EMB-HDW-SPD which then slides into the #EMB-HDW-SKT that you referenced. And the bracket attaches to the tractor with the included…
Hello Terry, thanks for reaching out. I do have a solution for you, and we do offer a roof rack system that can be used on your Leer 122 topper, but nothing that will have crossbars at different heights. For example, what I recommend for your Leer…
You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…
The Mighty Cord 50' RV Power Cord Extension #A10-5050EH that you referenced weighs 29 lbs. That may seem like a lot but it's a pretty thick cord that is 50 feet long.
For starters, a quick-fix type connector shown in your photo is typically a good choice for an emergency repair, but I wouldn't use it as a permanent fix. It looks like your trailer wiring has 3 separate grounds and 3 separate running lamp…
When a 4 flat connector on a trailer has 7 wires it usually means it either has extra grounds or extra tail light wires. Most likely if the extra wires are white then it is ground, if they are brown then they are most likely tail light wires. The…
You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…
Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
What our customers are saying:
"I received this order yesterday. Thanks for the outstanding service. I appreciate it! Thanks, Alex"