RoadMaster Even Brake Transmitter and Receiver

See what our Experts say about this Roadmaster Accessories and Parts

• Can Roadmaster EvenBrake Cab Wireless Receiver Be Mounted On Driver Side under Window
  You can mount the wireless receiver for the RoadMaster Even Brake System, part # RM-9430 on the side of the coach as you mentioned. You just want to make sure it is out in the open so that there is nothing obstructing the signal. Mounting it under the driver side window will work just fine.
  view full answer...
• Replacement RoadMaster Even Brake Transmitter and Receiver Recommendation
  I spoke with my contact at Roadmaster and he said it sounds like something has shorted out inside of the receiver and it will need to be replaced. If you bought your Roadmaster Even-Brake # RM-9400 within two years ago and you registered the product with Roadmaster when you purchased the product they will replace it for you. If you forgot to register it and it has been less than a year since you have owned this product it will still be covered by the warranty. If you are no longer covered...
  view full answer...
• Why Does Even Brake ICX Transmitter Connect to the Cold Side of the Brake Switch
  The cold side of a brake pedal switch only has power running to it when the brake pedal is pressed. This tells the system when the toad vehicle brakes are being applied. Data is sent by the ICX to the hand held part of the system that stays in the RV. Some vehicles will not have an active brake light switch when in tow-mode. In those cases there is a brake light switch kit needed. And in other cases a brake light relay might be needed depending on the type of lighting kit you are using. If...
  view full answer...
• Replacement ICX Transmitter for Even Brake Supplemental Braking System
  If all you are missing is the ICX transmitter then yes, you can just add it, # RM-9420, to complete the Even Brake system # RM-9400. If you are also missing the receiver part though you can get them both together as # RM-9430.
  view full answer...
• Replacement Monitor and Transmitter for the Roadmaster Even Brake System
  As long as the transmitter in the vehicle is still transmitting properly then you will not need any additional parts other than the replacement monitor # RM-9410 that you have referenced. If the transmitter is not sending out the signal then you can get both the monitor and transmitter together, # RM-9430. And if it is just the transmitter that is the problem you would need # RM-9420.
  view full answer...
• Can I Monitor The Braking System In The Motorhome When Using The Roadmaster InvisiBrake System?
  Although the Roadmaster InvisiBrake Supplemental Braking System # RM-8700 doesn't have a fancy transmitter/ receiver like the RoadMaster Even Brake System # RM-9430, the InvisiBrake system does have a LED monitor that illuminates when your towed vehicle's brakes have been activated. It lets you know if the brakes have been on for too long with an audible alert. at that point the system will automatically begin to release pressure after 15 seconds of continuous braking. The InvisiBrake system...
  view full answer...
• Replacement Transmitter For Roadmaster Even Brake Portable Supplemental Braking System
  The Roadmaster Even Brake Portable Supplemental Braking System # RM-9400 with serial numbers below 27497 is not inferior to the ones with a serial number higher than 27497. Roadmaster switched their circuit board manufacturer at this point. If you have an older RoadMaster Transmitter with your Even Brake pre 27497 you will need to get the RoadMaster Even Brake Transmitter and Receiver # RM-9430. For the Even Brake newer than 27497 you will only need the Transmitter # RM77FR
  view full answer...
• Transmitter and Receiver Recommendation for a Roadmaster Even Brake System
  Yes, the RoadMaster Even Brake Transmitter and Receiver # RM-9430 that you referenced would be the correct kit you would need to give you a transmitter and receiver for the used Even Brake System part # RM-9400 that you have. The breakaway system of the system will need to be properly installed before the Even Brake will be functional. If you are missing that you would want part # RM-650898. For a harness you would want part # RM-650900.
  view full answer...
• Is Transmitter Required for Proper Function of Roadmaster Even Brake Supplemental Braking System
  I spoke with my contact at Roadmaster regarding the Even Brake Supplemental Braking System # RM-9400. He stated that the Transmitter # RM-9420 is indeed required for proper operation of the system. The transmitter not only sends signals to the monitor in the cab so you know that everything is working properly but it also communicates with the system as you apply the brakes to allow for proper function. Without the transmitter the Even Brake would sense an error and would not work correctly....
  view full answer...
• Replacement RoadMaster Even Brake Transmitter and Receiver
  There are parts which could work for you, but there is not a pressure switch available as a replacement part for the Roadmaster Even Brake # RM-9400. What you may be asking about is the Even Brake Transmitter and Receiver # RM-9430; the Transmitter # RM-9420 is also available separately.
  view full answer...

Do you have a question about this Accessories and Part?