Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs

Installed on a 2018 E350 Ford Minnie Winnie. The package arrived really beat up but only a single cover was damaged. It was replaced quickly. Nothing was missing.

I had to shim it down from the frame about 1.5 inches using a bar of 1.5"x3"x 24" inch aluminum stock on each side. Then it would clear the fuel tank and the gray water.

Switches are installed in our garage under the bed. Wiring came from power panel which is fairly close to the switches so it all went fairly well. Wire nuts are not recommended so I had to hunt around to find connectors that would work.

I have not used it for camping so do not how well it will work to stabilize the vehicle. We do a lot of boon docking so will have to have some good blocking to level and stabilize. It feels a little better sitting on the street. I do wish there was a lockout for them being raised before moving the vehicle outside of PARK?979257

Click to Enlarge

Click to Enlarge

Click to Enlarge

After a year of use, they make a huge difference when parked overnight.

Roger - 03/10/2022

134332

Very pleased. Not that hard to install. These replace the weak stabilizers that came with the trailer. You'll need a jack and an electrical kit to complete the install.433546

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Still working just fine, Ive suggested it to anyone who askes about it.

RRR - 09/18/2018

43732

by: Richard04/25/2017

I got the jack for three reasons. My original jack was intermittent, it was bent and it did not level the trailer because it had only one motor. The new jack works great and it can level the trailer because it has two motors and the power required. It was not the easiest to install because of the increased size and it will not level the trailer if it is off more that 2 inches or so side to side. In spite of these drawbacks and the fact it added weight to the rear of the trailer I am very happy with the new jack.372285

Good. Only issue I have is it is slower than my old jack

Richard - 04/25/2018

37656

by: Jonathan03/28/2019

Your going to love this product. I was able to fit on to a 1987 Avion travel trailer I renovated for my sister (spectacular renovation). It made the camper rock solid. You can't feel anybody walking around, no high wind movement. It felt like we set it on a concrete foundation. It is a well designed product I will use in the future if I renovate another classic beauty, even my own every day travel trailer.

Great product. 614891

Excellent product

Jonathan - 03/30/2020

72004

by: Donald H.03/06/2018

i find these easy to operate. installation took a little time as i had to works underneath the camper. i have discovered, the middle of the jacks flex when leveling. i have some heavy angle iron, i am going to reinforce them. before i do that operation, i am going to add more bolts, that may be the simple solution.

overall, excellent product.481698

Scary at first, but following directions, it bolted right onto the frame, used a floor jack to hold it in place while attaching. Wiring was uncomplicated, except for figuring out where to route the wires. works fine, I am a happy camper!340760

still works great.

Glenn A - 02/10/2018

34539

I was very satisfied with the excellent service I received. Rose was very helpful. Box was a little tattered but all parts were intact. I installed stabilizers and they work as expected .Very easy to install as I did them myself194823

They are working great just as u expected very good product. Would recommend to anyone. Thanks Again to Rose for her help

Joe - 05/27/2016

18061

by: Butch M01/25/2020

On my 5 whl the landing gears froze up and would not turn either way. I ordered LC179013 and installed myself. That was s good job for an old 70Yrs fat man to do..
I got them installed and wired up and they work like a champ. That has been over a year ago and have been used alot. 745104

The product itself is a good product but the packaging for shipment is very bad. I received mine and the box was badly torn apart and tapped back together. I was missing multiple pieces and had to wait until the replacement pieces arrived. Customer service was very helpful with resolving this problem within minutes. 119770

by: Ken05/11/2016

I purchased 4 sets of these for 2 trailers. One motor intermittently will not run unless I remove the cover and turn it by hand. It occurred immediately after installation. Should have returned it.249800

by: James F07/24/2017

Installation was easy, need a helper just to make it safer. CSR people are great very helpful!! Works as promoted and I have recommended this product to other campers. 410247

Well after 1 year of use the Jacks are still doing very well we have gone on at least a dozen trips that they have been utilized. I am very glad to have purchase them, the installation was very easy great videos!! Best Regards P.S I have recommended to other campers and have even assisted on installing them.

James F - 07/26/2018

41519

Exact replacement of what was on the Carrilite 5'er with both products, the levelers and the front landing gear.
Fast efficient service as usual!172136

The product does what we needed it to d o.96172

Review from a similar Power Twin II in Camper Jacks

It looks like a great product am anxious to install them.
I have a symbol of them in my garage and I have one with a really crooked foot. The bolt hole on the retracting arm was drilled in the wrong place so it is totally crooked, not a deal breaker though. I’m sure the are more than Adequate1284349

Click to Enlarge

Our customer service team will be reaching out to you.

-- Katrina B - 04/22/2022

137350

Review from a similar Power Twin II in Camper Jacks

Finally got around to installing my PT II Stabilizers 30" front and rear of our 26' Surveyor. Pre - assembled them to make sure they went together ok. Luckily I had two sources for power front & rear which made wiring easy, I used a Buss block to make all positive connections, grounds straight to frame, soldered all connections and heat srinked to seal. Using the 3/8" self tappers was fun.Well got it all together and all works well makes trailer very stable, don't have to worry about scissor jacks collapsing anymore.422980

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Working well they make our trailer very stable compared to the sizzor jacks that came on our trailer well worth the money. Install was easy and had them spot welded to frame.

Chuck - 09/18/2018

43707

Review from a similar Power Twin II in Camper Jacks

After installation the stability or my toy hauler was increased X3. The installation was relatively easy and all that was needed was common tools and a floor jack. Wiring was covered by simple easy to follow instruction. Some shrink wrap and a solder gun make permanent water resistant connections which I recommend. 653355

Click to Enlarge

Click to Enlarge

Review from a similar Power Twin II in Camper Jacks

Would have been nice to know that it didn't fit my Grand Design Imagine 22MLE without some "frame modifications", and over $xxxx in installation costs.

Warning to new buyers; DO SOME REAL CLOSE MEASURING TO MAKE SURE THE SYSTEM
WILL FIT BETWEEN ALL ATTACHED HARDWARE, LIKE DUMP VALVES AND DROP FRAMES! any modifications will cost you dearly.

Electric motors are very slow, seems like it takes forever to drop each foot.

BUT----------They do work.1309587

We recommend physically getting under your trailer to see if there are any obstructions along where the PTII-30 mounting brackets, as well as the Main channel PTII-30, and the connecting bracket attach. This item adjusts along the channel anywhere from 48-80 inches long. The mounting brackets are 36 inches long from front to back.

Katrina B - 07/12/2022

143100

Review from a similar Power Twin II in Camper Jacks

I finished the assembly and install of the power twin II stabilizer and have included pictures of the install. This is a good quality unit and I am very happy with how it works.

Bob291792

Click to Enlarge

Click to Enlarge

Click to Enlarge

Review from a similar Power Twin II in Camper Jacks

I received the leveller/stabilizer as expected. The instructions for installation were clear and I found it easy to assemble and install them. Wiring was a bit tricky because of my trailer design, but worked out fine in the end. I have just returned from a three week trip and can recommend this product whole heartedly. One thought I have had is that a manual version might be satisfactory, using a drill to drive the gears until they engage with the ground, and then using a manual crank after that. The motors are a bit slow to drop the feet to the ground because they also have the necessary torque and gear ratios to lift the corner of the trailer. All in all, a great product.647307

I continued to use the trailer until parking it for the winter in the fall of 2019. The stabilizers continued to work well. I have nothing further to add, unfortunately, until this pandemic is done.

Jeff C - 05/28/2020

77852

Review from a similar Power Twin II in Camper Jacks

Helpful hint: Have in home position before tightening all the bolts. Best stabilizer I have found out there.1357232

Review from a similar Power Twin II in Camper Jacks

Nice product. Shipping was fast and communications were good. Heavy duty stabilizers, I'm sure they will be more stable than the old scissor jacks. The only problem I had was the one ear was broken off of the one switch. Does not effect function but when you buy something new you expect it to be right.523701

Works good no problems

Ken T - 06/19/2019

56816

Review from a similar Power Twin II in Camper Jacks

The Jacks are considerably more durable well built compared to the Lippert models. The lifting power is real and once on the ground the prevent movement of the RV by orders of magnitude over the other style jacks. I only have one in the center of a long trailer and it has stopped the bouncing and side to side swaying of the trailer. Just stepping onto the stairs to get in its rock solid. Also when all the legs are deployed the doors close way better than they ever had with just the Lippert jacks on the front and back. Definitely recommend to anyone thinking about a better jack than what's provided oem.307523

Review from a similar Power Twin II in Camper Jacks

I want to give this product 5 stars as they are a very nice set of stabilizer jacks that are very heavy duty but I'd have to say that the quality control from Ultra Fab is not great. The connecting bracket, part # 39-841642 on both sets was very poorly fabricated. On one set the holes were not drilled in a straight line and therefor did not line up with the holes on the jacks forcing me to drill new holes and on the other set the bracket was actually a whole quarter of an inch narrower at one end than the other and the jacks did not even fit into the bracket. Due to time constraints and not being able to be down more than a day after cutting off the old jacks I was forced to cut the bracket and weld it back together straight so that it was usable. Costing me an extra 2 hours of time and frustration. Nice jacks otherwise but I advise to assemble them completely and make sure the parts line up before removing your old parts. 662077

Review from a similar Power Twin II in Camper Jacks

easy install, works great, priced right 1444351

Review from a similar Power Twin II in Camper Jacks

This product is awesome and has made a substantial difference in the stability of our camper! We have a 32' travel trailer and the factory jacks are sad and could feel every movement of the kids. This has taken away 90% of the movement that we were having before.
If you are not handy plan on having someone install this for you. It's not hard to do but if you don't have some tools for the job you will struggle. It took about 4 hours total to install. 529220