Will Yakima Rack And Roll Trailer Need an Inspection in the State Of Texas  

I went to our warehouse and took some measurements of the Yakima Rack And Roll Trailer, part #Y08107. I have attached a photo of the trailer with the dimensions shown. From the center of the hitch ball coupler to the center of the front crossbar in…

The Rack and Roll trailers, like the 66 inch long model #Y08106, are rated to tow at normal highway speeds. As always, exceeding posted speed limits is not recommended, especially when towing. You may want to consider a spare tire #Y08121 for the…

Most states require the Yakima Rack and Roll Trailer, #Y08106, to be registered, but it registers just like a regular trailer. We provide you with a Manufacturing Certificate of Origin and a VIN number. Take the paperwork provided to your…

Yes you can, there's no reason you couldn't back the Yakima Rack and Roll trailers like the part #Y08106 into water at a boat ramp.

The inner tubes of the Yakima Rack and Roll #Y08106 wouldn't wear out quicker than the tread tire. Trailer tires should be replaced at 6 years so when you get to that point I'd go with the new #Y8880282 and a new inner tube part…

The Yakima Rack and Roll Trailer, #Y08106, weighs 150 pounds. With 2 people lifting, that is 80 pounds each. Two people could handle it, but it would be much easier to use some ramps like #11200, if you wanted to put it in a truck bed. Please note…

While there isn't a life expectancy, per se, of the shocks on the Yakima Rack and Roll Trailer - 66" #Y08106 and 78" #Y08107, upgrading to the HD shocks is absolutely a good idea if your gear weighs around 200 llbs and…

The Yakima Rack and Roll trailer part #Y08106 doesn't have any safe jacking points on it so if you were in need of changing the spare you'd have to remove the kayak and raise the trailer by hand.

I think your best option would be to get a Fulton Snap-Ring Swivel Marine Jack #F1410050149. This should attach to your 2 inch by 2 inch trailer frame and provide you with a light weight jack for your Yakima Rack and Roll trailer. You should be…

Yakima does not recommend backing their Rack and Roll trailers like the #Y08107 you mentioned into water as the bearings aren't sealed and neither are the electrical connections. Your best option would be to back it right up to the waters…

For a canoe carrier that would allow you to transport it with the hull facing down on the Yakima Rack and Roll Trailer part #Y08107 that you referenced you would want the Yakima KeelOver Rooftop Canoe Carrier with Tie-Downs #Y04069. This rack is…

Since we have started carrying the Yakima Rack and Roll trailer #Y08107 I have not heard any complaints regarding the wheel bearings failing and only a few instances where people wanted to replace the wheel assembly. If you need to replace your…