Replacement 2-1/2 x 1-1/4 Inch Amber and Red Trailer Clearance Lights and Chrome Base

Question

Question:

replacement lights and brackets

asked by: Chris N

1

Helpful Expert Reply:

Based on your picture it looks like you are in need of some replacement lights and a bracket. It looks like you will need amber light # A91AB, red light # A91RB, and bracket # A91CB. And if you need the single wire (since the lights will ground through the bracket and mounting hardware) use # A91LW.

expert reply by: Michael H

1

click to enlarge

Answer 1

The “SAE P2PC 98” you provided is a code used by the department of transformation and will not have any bearing on the correct replacement. In order to determine the correct replacement I would need you to either A) remove the lens and find the part…

view full answer...

Answer 2

Sealed lights would have to be replaced since there is not easy way to get them open and maintain functionality of the light. Your light looks similar to #A91AB. This light measures 2-1/2 inches across, 1-3/16 inches tall and 7/8 inches deep. It…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…

view full answer...

Answer 10

Hey Kitti, I attached a couple help articles to this page that detail how to determine how much solar power you would need. There are a few factors so there isn't a set number we can give you at this time. Check out the links (down below) and if…

view full answer...

Answer 11

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Answer 12

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt pattern…

view full answer...

Replacement 2-1/2 x 1-1/4 Inch Amber and Red Trailer Clearance Lights and Chrome Base

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching