Replacement Jack Recommendation for Boat Trailer with 5k Capacity  

The distance from the bottom of the mounting flange to the bottom of the outer tube on the Bulldog Round, A-Frame Jack part #BD155033 is 3-1/2". The mounting flange is 3/16" thick. I have attached a photo of these measurements for you as…

I went out to the warehouse and measured the Bulldog Round, A-Frame Jack , item #BD1700100317, and there is 7 inches of clearance from the top of the mounting flange to the bottom of the lowest point on the jack handle. It sounds like this is exactly…

The Curt Trailer Hitch Receiver #C98DR for your 2023 Hyundai Ioniq 5 will not reduce your ground clearance since it sits higher than the axle components on your Hyundai. It will affect your departure angle due to hanging below the rear bumper. This…

My recommendation is to have a custom adapter made for the height and length that you need on your 2010 Chevrolet Malibu with the Draw-Tite Trailer Hitch Receiver #36479. The center of the hitch pin is about 8-1/2" from your rear bumper. Any…

On the Curt Ball Mount #C45014 the distance from the center of the hitch pin hole to the back of the ball mount platform measures 6-1/2 inches.

For a 1-7/8 inch hitch ball to use with the #C45015 or the #C45014 you would want the part #A-80. For a 2 inch hitch ball you would want the part #A-82. Both of these have a 3/4 inch diameter shank that is 2-1/8 inch long.

I just spoke with my rep at Draw-Tite the bottom of the 1 1/4" receiver for the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" item #DT74MR sits 5 1/2" off of the ground. I have attached a picture of the…

The two Curt ball mounts you mentioned of part #C45014 and #C45015 are both options that would give you additional rise with the #C45015 being a few inches longer as well than compared to the #C45520 that you have now. Now these options only can be…

There is an easy way to make sure you clear the bumper on your 2004 Chrysler Town and Country. You will need a tape measure and a straight edge like a yardstick or a dowel. Hold the straight edge vertically against the rear bumper, making sure it…

The stop inside the hitch is not to force customers to purchase certain brand products, but to ensure that a Class II draw bar is not inserted into a Class I hitch. The Draw-Tite hitch you have, part #24812, is a Class I hitch so if the welded stop…

You are probably OK but if you are anything like I am it would be too close for comfort. I wouldn't want to take a chance at potentially causing any damage to my fascia. I recommend the Curt Class II Drawbar - 5" Rise - 11-5/8" Long -…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…