Will Fulton Marine Jack Fit Trailer Mounting Plate For Shelby Jack  

I do have an option for you but the Shelby trailer jack mounting bracket that you have welded to your frame won't be able to be reused with any newer jack. The Shelby trailer jacks did use similar designs in regards to mounting like the…

It sure does! If you take a look at the accompanying photo I added from an install we did, you can see the Ark Off-Road jack installed on a C-channel trailer frame. The correct part number for this jack is the following: - Extreme Off-Road Swing-Up…

For your Shelby 5856A boat trailer, I recommend the Fulton Bolt-Thru Swivel Marine Jack with Dual Wheels - Sidewind - 12" Lift - 1,500 lbs #FXPD15L. This jack has zinc plating for corrosion resistance and durable poly wheels. For the single…

This is actually something that has come up before. Fulton will typically only list the jack's capacity on the jack, but not a part or model number. Since you found the 1,200 pound capacity, measured it at 16", and mentioned it being a bolt…

To replace your Shelby 5856A jack I recommend the Fulton Round Snap-Ring Swivel Marine Jack #FTJ120W0301. We have had customers say that this fits the mounting plate for the Shelby 5784A perfectly. This jack features a lift capacity of 1,200 pounds,…

The Fulton jack #FXP15, is not meant to be mounted through the center bolt. It is designed to use the included mounting hardware that fits around the trailer frame. This will allow it to operate correctly and support the weight it is rated for (1,500…

The only bolt-on swivel jack we have that works with 6" tall trailer frames is the Trailer Valet 5X Swivel Jack and Trailer Mover part #STC-V211. The Trailer Valet has a 500 lb tongue weight capacity and works with frame rails up to 2-3/4"…

I went out to the warehouse and took a few measurements of the mounting bracket on the Fulton Bolt-Thru Swivel Marine Jack #FXP10W0301 and found that the widest part of the indented hole is 1-12" while the hole that the bolt goes through…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…