1,200 lb Capacity Fulton Jack Recommendation  

I have an option for you, but the smallest marine jack with the smallest snap ring mounting hole is the Bulldog Round, Snap-Ring Swivel Jack - Sidewind - 10" Lift - 2,000 lbs - Zinc Finish #BD151109 which measures 2-1/8". You best bet to is…

Jack #DL22210 isn't a snap ring jack but we do have other options that will likely work with your existing mount such as #FTJ120W0301. The hole spacing for the pull pin is 3 inches apart on center. I have linked a video review of this jack for…

The correct replacement for the Fulton Magnum Series Trailer Jack on your trailer is the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 if you have a bolt-thru mounting bracket or part #FTJ120W0301 if you have a snap-ring mounting bracket. I…

Since you have a Fulton jack you will want to replace it with a Fulton so that you can reuse the same mount. For that jack #FTJ120W0301 is going to be the best option.

Based on the picture you submitted the Fulton Marine Jack part #FXP100W0301 that you referenced would be exactly what you'd need and would bolt right up to the mount you have on the trailer frame.

I have a replacement jack option for you, but after reaching out to my contact at Fulton the plate you showed in your picture is not offered as a replacement part. Your only option at this point is to go ahead and replace your jack with the Fulton…

The Fulton Magnum jack used the #P9012-00 weld-on bracket which would be compatible with the bracket included with the 1200 lb Fulton Jack, part #FXP100W0301 or the 1500 lb model, part #F1411300301. If your attachment bolt that attaches the jack to…

The jack I recommend to replace your Fulton 1000 lb jack with bolt through is the Fulton Bolt-Thru Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,500 lbs #FXP15W. This is a very sturdy jack that will give you a little added safety as you…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…