bing tracking image
Q & A Icon

What are the Dimensions of the Jack and Handle in the Leveling Scissor Jack Set, # JSC-24

Question:

97 16 Casita, like to put these on the front corners, when compressed-what is the dimension from bolt on bracket to crank bolt head? what is the dimension of the handle from the U to the end that attaches to the jack? Also what are the dimensions of the bolt on bracket on top of the jack? Thanks

0

Expert Reply:

I went out to the warehouse to measure a jack and handle included in the Leveling Scissor Jack Set, # JSC-24. When compressed, the distance from the end of the crank bolt head to the center of the jack (between the two brackets) is 13-7/16 inches. When extended, it is about 4 inches.

The brackets measure 3-11/16 inches long by 3-3/16 inches wide by 1-3/4 inches tall.

The 2 outside round holes on each bracket are 5/16 inch diameter and 1-1/2 inches apart on center. The 4 elongated holes are 11/16 inches long and 7/16 inches wide. The center distance between any hole across to the other hole is 1-1/2 inches. The center diagonal distance from one hole to the adjacent hole is 3/4 inches.

On the handle, from the center of the U handle to the end that attaches to the jack is 18-1/8 inches.

From the end of the handle to the nearest part of the U is 14-1/4 inches. To the furthest, outside part of the U it is 22-1/4 inches.

The U portion at its widest point is 8 inches, outside to outside. The handle is 28-1/2 inches long.

expert reply by:
0

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>