Recommended Ramp Springs For Heavy Equipment Trailer
Question:
I am building a set of ramps for a heavy equipment trailer. The ramps will weigh approximately 250-300lbs each. How many springs should be installed to make the ramps easy to lift but still fold down?
asked by: Aron
0
Expert Reply:
The Redline Ramp Spring like part # RS16933RH and part # RS16933LH will help with lifting the ramps you said you are building for your trailer. I would recommend 1 spring for each ramp.
These springs are made of steel alloy, these springs provide approximately 90 degrees of deflection and are designed to help lift a ramp with 2,000 pounds of torque.
expert reply by:
Jeffrey L
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Conventional Ramp Door Spring for 8' Wide Enclosed Trailer - Dual Spring - 250-lb Capacity
- Search Results: spring
- Search Results: trailer ramp spring
- Search Results: ramp door spring
- Shop: Conventional Ramp Door Spring for 5' Wide Enclosed Trailer - Single Spring - 85-lb Capacity
- Shop: Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Q&A: How to Choose the Correct Ramp Spring for a Trailer
- Q&A: Choosing/Sizing the Correct Trailer Ramp Spring for a Ramp Door
- Q&A: How to Determine Required Capacity of Trailer Ramp Torsion Spring
- Shop: Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Search Results: led clearance light
- Search Results: d ring
- Shop: Replacement Swivel Pin Kit for Trailer Jacks
- Search Results: trailer spring
- Search Results: air bag suspension
- Shop: Gooseneck Hitch
- Shop: B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Q&A: Trailer Ramp Springs for a 20 Ton Tandem Axle Trailer
- Shop: Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Q&A: Left Hand Vs. Right Hand Placement of Ramp Springs on a Trailer Ramp
- Shop: Trailer Wiring
- Q&A: Can Two Ramp Springs Be Used On Each Side Of Trailer Ramp
- Video: Deka Jacketed 4-Wire Review
- Q&A: Replacing Mobile Home Trailer Hub With a Hub that is Compatible with Standard Rims and Tires
- Article: How to Measure a Trailer Axle
- Video: Comprehensive Review: Conventional Ramp Door Spring for 8' Wide Enclosed Trailer
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Video: Finding the Right Trailer Wiring Harness
- Shop: Brake Controller
Explore Expert Info
![Our Expert]()
on Trailer Ramp Springs
on Trailer Ramp Springs
