bing tracking image
Q & A Icon

Can the Wiring Harness In Diode Wiring Kit # RM-154 be Routed Through the Frame on 2010 Honda CR-V


I have purchased a Diode Wiring Harness - Roadmaster, Can the Wiring be run through the frame of a 2010 CRV? If so, how?


Expert Reply:

It is possible to route the wiring in the Roadmaster Universal Hy-Power Diode Wiring Kit, # RM-154, through the frame of your 2010 Honda CR-V if the frame rails are hollow all the way through (front to rear) and if there is easy access to the frame rail from the front to the back of the vehicle. I have included a video below.

Our installer in the video does pull the harness through the frame rail using a wire pull similar. He first routes it through the back of the frame and the wire appears near the front suspension. Then, he tapes the harness to the wire and pulls it through the frame from the back of the vehicle. Your CR-V may be similar but the only way to tell is to attempt to route something like the wire pull through first.

If you find you cannot pull the wires through the frame, I recommend routing the wiring along the outside of the frame rail instead of inside of it. You can follow along existing wiring and use wire ties and wire loom, like # 39035, to attach and secure the diode wiring. Be careful to avoid areas that may pinch or burn the wires such as moving suspension parts and the exhaust system, and stay clear of fuel lines.

expert reply by:

Products Referenced in This Question

Product Page this Question was Asked From

Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>