Installing Brake Controller And Wiring On 2001 Ford Explorer Sport Trac
Question:
Which wire out of the white yellow green and brown/white are the brakes for a trailer wire harness on a 2001 Ford Explorer Sport Trac
asked by: David
Expert Reply:
It sounds like you are wanting to install a brake controller and wiring for your trailer on your 2001 Explorer. The wires you mentioned will probably not be the wires for the brakes you asked about.
If you do not have a factory trailer connector on your Explorer I recommend first installing the Draw-Tite hardware kit, part # 18252. You will need to locate the tail light wiring harness and use the included circuit tester to test the wires by function, and connect them to the harness. The white wire is the ground and should be attached to a clean bare metal surface with a ring terminal. The brown wire is attached to the tail light wire. The yellow is attached to the left turn wire and the green is attached to the right turn wire.
Then you need to use part # ETBC7 to complete the installation. This harness plugs into the 4-way on the vehicle and the balance of the wires are installed as explained in the linked helpful article.
I recommend a brake controller like part # 90195. This is a really popular brake controller because it is easy to install and operate. You will have a red wire exiting the brake controller. That gets connected to the cold side of the stoplight switch located at the top of the brake pedal under the dash. The cold side of the switch should only show power when the brake pedal is pressed. I have attached a drawing that shows how the wiring is run when installing a brake controller.
Products Referenced in This Question
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Brake Controller
- Article: Trailer Wiring Diagrams
- Shop: RV Roof Membrane
- Shop: Van Cargo Mat
- Search Results: 480~12 trailer tires and wheels
- Shop: VanTred Custom Floor Mat for Cargo Vans - Black - Thermoplastic
- Shop: Conventional Ramp Door Spring for 8' Wide Enclosed Trailer - Dual Spring - 120-lb Capacity
- Shop: CargoSmart Anti-Rattle D-Ring Tie-Down Anchor - Bolt On - 3/8" x 2-1/4" - 1,667 lbs
- Shop: Buyers Products 3/4" Forged D-Ring With Weld-On Mounting Bracket
- Shop: LaSalle Bristol XTRM Universal Self-Leveling Sealant - White - 10.1 oz - Qty 1
- Search Results: e track d ring
- Search Results: fender flare
- Search Results: d ring
- Search Results: roof sealant
- Shop: Shackle Bolt For Double-Eye Springs - 9/16" Diameter - Plain - 3" Long
- Shop: Shackle Bolt with Locknut For Double-Eye Springs - 1/2" Diameter - 3" Long
- Search Results: 4 way extender
- Search Results: coupler
- Q&A: Brake Controller Installation on a 2007 Ford Expedition with Factory 4-Way Wiring Harness
- Video: Beginner’s Guide to Installing the Curt Trailer Hitch Receiver on a 2016 Ram ProMaster 2500
- Video: Beginner’s Guide to Installing the etrailer Trailer Hitch Receiver on a 2019 Toyota RAV4
- Video: Feature Breakdown: Universal Installation Kit for Trailer Brake Controller
- Q&A: Curt Echo Brake Controller Will Not Pair To Phone With Working Bluetooth Connection
- Shop: Towing Mirrors
- Article: Curt Echo Full Review
- Q&A: Comparing Curt Echo And Redarc Tow Pro Elite Trailer Brake Controllers For 2019 Nissan Titan
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2023 Kia Sportage
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)