How to Pick Out Brake Assemblies for a 2008 Starcraft 21SB  

The right and left orientation is determined if you are standing behind the trailer looking towards the tow vehicle. The left side is the drivers side and the right side is the passengers side. Tthe shorter brake pad will always be in the front of…

The bolt hole pattern for the brake assembly #AKEBRK-35L is 2-7/8 by 2-7/8 inches. I've linked a diagram of the flange the brake will install on with the same pattern. The shipping weight is 9 pounds. This is the left hand brake, if you also need…

The bolt pattern of the Electric Trailer Brake Assembly #AKEBRK-35L that you referenced is 4 on 4 inch. If you check out the picture I attached you will see all the dimensions of the flange. You might try measuring yours again to be certain as it…

You will need one of two sizes depending on the axle capacity of your Bri-Mar dump trailer. If you have 7,000 lbs or 8,000 lbs axles, then you will need part #21-43-1 and #DC-RP if you have EZ Lube spindles (grease zerk on the end) or you can use…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt pattern…

The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…