What Gooseneck Hitches Work With Curt X5 5th Wheel Base Rails Adapter  

According to my contact at Curt, the X5 does not require a support kit because it has the rails and attachments needed as part of the assembly. It sits flush with the bed so it does not need a separate subkit because the subkit is already installed.…

Sounds like you may not have a B and W gooseneck hitch since that brand uses square holes. Could you possibly check under the truck bed to see if you can see a brand? With more info I could see if we have a suitable adapter.

Yes, the Curt X5 Fifth Wheel Adapter for B&W Square Shank Turnover, will allow you to use your Reese 15K Fifth Wheel hitch. The Curt Adapter works with Curt 16K and 20K hitches as well as Reese Fifth Wheels up to 20k among other manufacturers.

The Curt X5 5th Wheel Base Rails Adapter for B&W Turnoverball Gooseneck Trailer Hitches - 20,000 lbs #16310 has a measurement of 14 inches from the front rail edge to the center of the gooseneck. I went to our warehouse to measure it for you.…

The bed rails used on the Curt X5 Fifth Wheel Adapter are indeed compatible with Reese standard and sliding hitches. This particular adapter is only compatible with B&W Turnover Ball Gooseneck Hitches using a square shank. I have linked you to…

The shaft that fits in the gooseneck hitch on the Curt X5 adapter, #16310, is centered between the two 5th wheel rails. If you were to measure from the center of that shaft to the rear edge of the back rail or to the front edge of the front rail it…

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

Yes it does! The B&W Companion 5th Wheel Hitch #BWRVK3600 that fits your 2018 Ram 2500 with the factory puck system is completely compatible with a MORryde cushioned pin box. This is a fantastic set up, giving you a cushioned pin box along with…

You can definitely use a cushioned pin box with the B&W Companion 5th Wheel Trailer Hitch #BWRVK3400-5W like a Mor-Ryde, Trailair, or 5th Airborne. For more info on 5th airbornes and for a review video of the hitch check out the links I attached…

Yes. If you change no other components, the hanger length increase should directly correspond to the lift of the trailer. So, if you use a tandem axle kit like the Tandem-Axle Trailer Hangers for 1-3/4" Wide Double-Eye Springs - 3-1/4" Tall…

It sounds like you are talking about moving your leaf springs down further on the hangers installed on the frame of your trailer. If that is the case then as long as each end of the spring is moved down the exact same distance, you will get the much…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…