Availability of Replacement for Trailer Hub/Brake Drum 92865A-1

Question

Question:

Are these hubs a replacement for hub 92865? Thanks

asked by: Craig K

0

Expert Reply:

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek # AKHD-865-7-2-K hub drum you referenced. The # AKHD-865-7-2-K would be an acceptable replacement for your existing hub/drums, assuming that your existing grease seals have an ID of 2.25 and an OD of 3.376.

expert reply by: Mike L

0

Sam C.

2/27/2020

The number I have off inside of bearing is 25520 which it could of been wrong before every thing else matches up

Reply

Chris R.

2/27/2020

The 25520 you mentioned is actually the number for the race that's used with the # 25580 bearing - not the bearing itself. So this only further points to the etrailer Hub and Drum # AKHD-865-7-2-K that Mike mentioned as being the correct replacement for your trailer.

Helpful Links

Trailer-Bearings-Races-Seals-Caps/etrailer/25520.html

Reply

Answer 1

For your 2023 Subaru Outback, I recommend the Curt Trailer Hitch item #C69VV. This hitch is custom fit and bolts to your Subaru with included hardware. This is a class III hitch with a 2" receiver. I really like this hitch because it is an easy…

view full answer...

Answer 2

The spring center length on your current axle does not matter when it comes to finding a replacement. The most important piece of information is the length of the axle, which is the hub face to hub face measurement. As long as the hub face…

view full answer...

Answer 3

It sounds like you may have a replacement axle that wasn't fitted properly. You will want to make sure you have matching axles as that natural misalignment will cause tire wear issues and can lead to sway issues as well. I've linked the page…

view full answer...

Answer 4

The Landing Gear Kit part #RVLG-8000 that you referenced is a fit for your 2004 Keystone Everest. This kit is designed to fit trailers with weld stops that are 17-1/2 inches apart from each other measured on the outsides of the stops. I attached a…

view full answer...

Answer 5

I was able to locate Fan-Tastic Vent 8613-01, however that number came back to it being the document number of the manual which covered 8 different vent/fan options. If you can provide me with the model number of your vent (which can usually be found…

view full answer...

Answer 6

Currently Lasalle Bristol does not offer a replacement lens for the Gustafson 12V RV LED Puck Light GSL9538 #277-000344. You would need to get the entire light or switch to a different light like the Command Electronics #328-K-58L34P9 which offers a…

view full answer...

Answer 7

If you would like to remove the manual crank hand knob from the Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote part #FV807350 you could easily. That is the only part of the manual crank assembly that would be easily removable. The knob itself only…

view full answer...

Answer 8

The big difference is the corners of the main panel of the #FV807357 are cut out with small section to allow access to mounting hardware and the #FV807359 instead does not have this area cut out. So you'd want to look at your vents to see if you…

view full answer...

Answer 9

The Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote - Powered Lift, #FV807350 has a knob on vent housing allowing it to be operated by hand in case of power failure and this also allows for manual positioning. Opening with the remote will cause the…

view full answer...

Answer 10

I'm sorry you've been experiencing that with MaxxAir. Normally they are very responsive and offer a solution to any issues. In place of your MaxxFan I recommend the Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote - Powered Lift - 14-1/4"…

view full answer...

Answer 11

The Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote part #FV807350 is a complete assembly that will completely replace an existing vent. The Fan-Tastic Vent Roof Vent Assembly Upgrade Kit part #FV807357 is designed as an add on to existing vents. The…

view full answer...

Answer 12

If you are referring to the removable attachment tabs then, yes, we do have that part. You will want part #BLU57XR. I have included a link to a video review of this part for you. If this is not the part you need then I have included a link to the…

view full answer...

Availability of Replacement for Trailer Hub/Brake Drum 92865A-1

Product Page this Question was Asked From

Continue Researching