Replacement Drive-In Wheel Stud for Hub/Drum BS2-655  

The exact replacement hub assemblies you need are the AxleTek Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 #AKHD-545-35-K. These assemblies come with the bearings, races, seal, grease cap and even the lug nuts…

I couldn't be 100% positive about which wheel studs you'd need without seeing the trailer and being able to measure. I just don't have enough information. This bein said, by virtue of the trailer having a 5 on 4-1/2 inch wheel bolt…

The exact replacement hub assemblies you need for your BD2-545-17 are the etrailer Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 #AKHD-545-35-K that you referenced.

Most wheel studs are pressed into hubs so what you can do is use a large punch or chisel and a hammer to hammer the broken studs out of the hub and then reverse the process to install new ones.

We do have the Replacement Trailer Hub Wheel Stud #165981 which is 1-1/2" long with a 1/2" diameter. This is a drive-in stud which is pretty typical on trailers. If you need more than 1 we have the 4-pack as part #RG03-020. I am attaching a…

The seal you need for your trailer hub is the #58846. Or for a bearing kit that includes all of the components you'll need you'd want the #BK2-100. For brake assemblies you'd want the part #AKEBRK-35L for the left side or part #AKEBRK-35R…

The standard replacement drive-in wheel stud for a 3,500 lb hub/drum like what you have on your Lippert 3,500 axle is the part #7-122 which is the correct thread size and length.

I took a look at the wheel lug stud LCI SKU 121803 you mentioned, and I was able to find the Kodiak Wheel Bolt #K12WB2. This bolt is 2" long, and has a thread size of 1/2"-20 UNF-2A.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt pattern…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…