Making Modifications to Lippert 6.0 Leveling System on 2017 Cedar Creek Champagne 38EL

Question

Question:

If I use the adapter lugs can they be installed on the 6 point hydraulic level up. I have a 2017 Cedar Creek Champagne 38EL. We are full timers and the washing machine gives us a little shaking. I made my own for my other 5th wheel and the work great.

asked by: Brian R

0

Expert Reply:

The Lippert 6.0 leveling system must be installed and serviced by a Lippert-certified technician. I do not recommend modifying this new system until you speak to your trailer dealer (or to Lippert at 866-524-7821) to confirm you will not jeopardize any warranty coverage on the trailer or leveling system by making modifications to it, such as by adding the stabilizers # LC191023. Lippert is the best source for information on making any mods since they produced the kit, the leveling system and in all likelihood, the trailer's frame too.

expert reply by: Adam R

0

Answer 1

The JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ 58" or More Between Landing Gear #LC191023 will work with your 6,500 lb rated landing gear. This kit does not support any weight so it does not have a specific capacity it is rated…

view full answer...

Answer 2

Yes the JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ 58" or More Between Landing Gear #LC191023 can work with your Levelup hydraulic stabilizer jacks.

view full answer...

Answer 3

Can you send me a picture of the feet of your jacks? How far apart are they?

view full answer...

Answer 4

It sounds like you are looking for the Valterra Eccentric Tank Reducer part #T1041-1 which installs in an RV gray water tank with with 3" diameter opening and then reduces this down to 1-1/2". The adapter will install inside the neck on the…

view full answer...

Answer 5

The Portable Power Watchdog Surge Protector with Bluetooth - 30 Amp #HU97FR allows you to watch for surges while connected to a parks shore power. The acceptable power range is between 104 volts - 132 volts. I would set your parameters slightly above…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

Hi Joseph, If your leveling system has a round tube design then you won't need the Replacement Swing Bolt #LC314596 and would instead need adapter lugs #LC314592 and shorter swing bolts #LC314595. The adapter lugs can be bolted to the footplate…

view full answer...

Making Modifications to Lippert 6.0 Leveling System on 2017 Cedar Creek Champagne 38EL

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching