Fulton Jack to Replace Swivel Jack on Ranger Trailer
Question:
Hello, I have a Ranger Trailer with a Fulton side wind swivel jack. It has 8inch of lift and rated at 1200lb. It mounts to a bracket welded to the frame and the bolt centers are 5.5inch width and 3inch height , but is not held together with a snap ring, but a bolt. Do you have a direct replacement for it? I do not want to modify the trailer frame. Thank you
asked by: Bruce W
0
Expert Reply:
Based on what you described it sounds like the part # FTJ120W0301 is what you need. If the inner diameter of the welded on mount on your trailer for the jack is 2-1/4 inches it is the same mount that the # FTJ120W0301 would fit.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Replacement Jack for Trailer that Had Shelby 5756A
- Q&A: Replacement For Shelby 5776 Trailer Swivel Jack
- Q&A: Shelby Model # 5784 Trailer Jack Replacement Option
- Article: Trailer Jacks
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Q&A: Can App be Used with Air Lift WirelessAIR Upgrade Kit AL87DQ
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Best Boat Trailer Jacks
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)