Lock for Older Yakima Rock Series Hitch Bike Rack  

If you are looking for a strap to secure the front wheels of your bikes to prevent them from moving around you would want the Replacement Wheel Holder Strap #HRSPRVEL. With this strap you can secure the front wheel to the frame of the bike so that…

The correct hitch lock for the Kuat Beta item #B202-2 is the Hitch Lock for Kuat Bike Racks - 2" Hitches item #HL2. I have linked a review video.

For your Kuat Beta bike rack #B202-2 the easiest solution to lock the bikes to the rack and to the hitch is to use a cable lock such as #e98891. Run the cable through the bikes and the safety chain loops on the trailer hitch to deter theft. I have…

Kuat recommends the part #H101 for the Kuat Beta for 2 inch hitches part #B202-2 that you referenced. The usable span of the hitch lock is 3-1/2 inches which would be more than enough. Usually 2 inch hitch accessories use 5/8 inch hitch pins, but…

Kuat offers two different hitch locks, the #HL1 for the #B202-114 Beta that's designed for the 1-1/4 inch receiver and the #HL2 lock that's designed for the #B202-2 Beta rack that's designed for the 2 inch receiver. So it depends on which…

Kuat offers two different hitch locks, the #HL1 for the #B202-114 Beta that's designed for the 1-1/4 inch receiver and the #HL2 lock that's designed for the #B202-2 Beta rack that's designed for the 2 inch receiver. If the correct lock is…

To lock your bikes to your vehicle when using the Kuat Beta part #B202-2 that you referenced you'd want to use a cable lock like the etrailer Cable Lock #e98891. You'd want to route the cable through the bike frames and then back to through…

In a situation like this there are a lot of variables, like bike rack, bikes, tow dolly, car on dolly, etc, so there is no easy way to figure this out. It is going to take a bit of measuring and basically mocking the situation to see if a set-up will…

The correct replacement hitch pin for a Yakima OnRamp bike rack #Y36FR is the part #Y8890200 and then for the locking core for the end of it you'd need the part #Y07235 and you'd be set.

There is a way to key a Yakima HitchLock, part #Y07235, the same way as your Yakima Yakima Holdup 2 Bike Hitch Mounted Folding Rack, part #Y02443. What you will need to do is find the lock number that should be stamped on the front of the lock…

This is a good question, as a lot of people want to know the real differences between the Thule EasyFold XT #TH903202 (which fits both a 1-1/4" - Class I and II & 2" hitch) and Yakima OnRamp #Y96FR (fits 1-1/4" hitch - Class II…

The Yakima HitchLock for Yakima Hitch Mounted Bike Racks #Y07235 attaches to your anti-rattle bolt and keeps your bike rack locked to your hitch. An even more secure setup is the Yakima LockUp Hitch Lock and Cable Lock #Y07238. This kit not only…