Keyed Alike Locking Pin For Ball Adjustment And Hitch Pin On Fastway Ball Mount  

Hey Jonathan, congrats on the new truck. The 7" drop should be enough, but it is hard to say for sure without knowing what trailer you will be pulling. The 7" drop will get your ball height at 17" or 18" (we measure from the upper…

From your photo, it looks like you need the replacement side adjustment bolt for Fastway Solid-Tow Adjustable ball mounts part #DTBM29. The side adjustment bolt tightens the ball platform to the ball mount.

On a trailer electric brake assembly like the Dexter 6,000 Pound #23-105 you were looking at the magnet itself should be at the bottom. The arm that is attached to the magnet should then be located on the front side of the trailer (towards the…

Adding trailer suspension enhancement such as #TTRA1702 can definitely help with ride quality but I think the best solution to keep loads on the pallet is some cargo control devices. You could start with a cargo net, I have included a link to the…

There sure is! The correct locking pins for the Curt Channel Style Adjustable Ballmount - 5-1/4" Rise, 6-3/4" Drop - 6,000 lbs #C45901 is the Curt Lock Set #C23556. This set includes one lock to lock the ball mount section to the channel,…

In regards to the Buyers Products 3" to 2" Receiver Tube Adapter part #337RTA302 which is a great option for a Ford F-350, the adapter will actually reduce the towing capacity of the trailer hitch and vehicle while in use to 12,000 lbs of…

The factory installed hitch on the Tundra is wider than a typical 2 inch receiver, so a normal 2 inch hitch lock won't fit. We offer an extended length lock, part #e98881. Multiple locks are available keyed alike, use the drop-down box on the…

I went out to our warehouse to take a look at the B&W Tow & Stow 3-Ball Mount #BWTS20049B referenced in your question. I measured a total length of right at 11 inches of the vertical adjustment shank on the ball mount. I have attached a short…

Malone doesn't make that particular anti-rattle device in a size for a 2-1/2 inch receiver, but might have a thing or two that could work for you. Take a look at the Gen-Y Anti-Rattle Clamp, part #325-GH-063. The wedge portion is 1 inch long as…

The B and W Tow & Stow 3-Ball Mount #BWTS20049B that you referenced would be a great choice for your situation. It fits the 2-1/2 inch hitch your 2019 Ford F-250 has, gives you all three popular hitch ball sizes, and can do a drop of up to 7…

The Curt 21K Heavy Duty Forged Ball Mount #C45432 is intended for extra-heavy-duty 3-inch hitch receivers. It does have the 8-inches of drop you need, but we have similar ball mounts in the 2-1/2-inch hitch size you require and you can see these on…