Needing the Torklift Camper Tie-Downs for a 2016 Ram 3500 4X4 Dual Rear Wheels

Question

Question:

I have a 2017 Ram 3500 4x DRW With a factory hitch and I want to add the original torqlift to it. Im trying to figure out which camper tie downs I need. there are no steps at the bed, it has an original 2.5 in hitch right now.

asked by: Richard O

0

Expert Reply:

We have the camper tie-downs that you will need.

The Torklift Custom Frame-Mounted Tie-Downs, # TLD2124 for the front and, # TLR3507, for the rear will fit the 2016 Ram 3500 with factory hitch, 8 ft. bed, and no step boards mounted along the bed. The Torklift tie-downs are designed to mount to the frame of your vehicle. This product has a limited lifetime warranty and is made in the USA.

Note that the Torklift camper tie-downs cannot be installed on a vehicle that have factory airbags installed. Since your Ram has dual rear wheels, you may require # TLA7004 when installing the tie downs. Part # TLA7004 is a anchor relocation kit. This kit will relocate that rear tie-down anchor points to compensate for the width of some dually trucks. Adapter kit will most likely be needed if the distance between the front bumper of your camper and the center of the rear anchor point is less than 90 inches.

I also recommend the Torklift Locking FastGun Turnbuckles, # TLS9526-2-LK in polished stainless steel, # TLS9529-2-LK stainless steel in black, and # TLS9522-2-LK stainless steel in gray. The Torklift turnbuckles will secure camper to you ties downs and with the FastGun lever action design theses turnbuckles are easy to operate.

I attached videos on both installing the Torklift tie-downs and a review of the Torklift turnbuckles for you to review.

expert reply by: Jared P

0

Answer 1

The correct Torklift camper tie downs you need for your 2017 Ram 3500 dually without steps and a factory hitch is the part numbers #TLD2124 and #TLD3109 for steel or if you prefer aluminum which will be more corrosion resistant as part numbers…

view full answer...

Answer 2

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 3

Hey Bob, Roof rack systems are typically only rated up to 165lbs because that's typically above the capacity of the vehicle's roof. More recently all manufacturers are switching to removing the capacity from the listing and telling consumers…

view full answer...

Answer 4

Hi KJM; assuming you have the factory trailer hitch the correct TorkLift camper tie-downs for your 2024 Sierra 3500 dually is the Custom Fit Tie Down Kit With TL44FR | TL84FR #TL94PR. This will fit with that built-in step you're referring to as…

view full answer...

Answer 5

This will depend on if you have a Dually #TL94PR or Single #TL67DR rear wheels on your 2021 Chevrolet Silverado 3500 long bed. These are a fit for the factory receiver, if you have or want to switch to a TorkLift Receiver #TL74FR this would use a…

view full answer...

Answer 6

Hey Tim, Good questions, and camper tie-downs are always a touch confusing so I can explain the difference for you between the two TorkLift camper tie-downs for your 2016 Ford F-250 long bed with factory hitch and no running boards. The difference…

view full answer...

Answer 7

The channels of the RetraxONE XR part #RTT-82383 are a standard size which means standard roof rack t-bolts like the #853-5715 would work.

view full answer...

Answer 8

Hey James, The correct rear camper tie-downs to go along with your new TorkLift SuperHitch Original Trailer Hitch Receiver #TLD1102 are going to be part #TLR3505. These will mount directly to the hitch at the end of the crosstube.

view full answer...

Answer 9

Hello Volker, thanks for reaching out. For your 2024 Chevy Silverado 2500 6.5' bed with steps in front and back of the bed you can use the following Torklift Camper Tie Downs: - Custom Fit Tie Down Kit #TL86NR Keep in mind that these will only…

view full answer...

Answer 10

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 11

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

view full answer...

Answer 12

For a 3,000 watt inverter you'll need a 300 amp hour lithium battery like the Go Power Sun Cycle Advanced Lithium RV Battery item #GP26QR.

view full answer...

Needing the Torklift Camper Tie-Downs for a 2016 Ram 3500 4X4 Dual Rear Wheels

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching