Question:
Looking at your list of questions and answers for the Titan T4853100, it is immediately apparent that the coupler pictured in the very first answer by Michael H. has a different bolt pattern than the coupler pictured in the other answers or on the main listing. Which bolt pattern is correct? Additionally: 1 What is the actual internal width of the coupler channel, the part that fits over the trailer tongue? 2 How thick is the steel from which the channel is fabricated? I am guessing it is 1/8inch or 3/16. Thank you.
asked by: Eric P
Expert Reply:
The bolt pattern showing two slightly higher holes 3 inches on center and two slightly lower and larger holes 5 inches on center from each other is the proper bolt pattern.
The part that actually fits over the trailer tongue has an internal width of 3 inches. It is fabricated from 3/16 inch steel and is zinc coated giving it about a 1/4 inch thickness. I've attached a video where you can see these measurements.
Titan Zinc-Plated Straight-Tongue Coupler - 21,000 lbs
