Recommended Ball Mount for 2012 Ford F-350 with 2-1/2 Inch Hitch Receiver  

The B and W Tow & Stow 3-Ball Mount #BWTS20049B that you referenced would be a great choice for your situation. It fits the 2-1/2 inch hitch your 2019 Ford F-250 has, gives you all three popular hitch ball sizes, and can do a drop of up to 7…

You will need to add a 2 Gallon Air Tank #F9126 to the Air Lift WirelessAIR Compressor System #AL74000EZ to handle the large burst of air required for your air horn. You will need to insert a Union T #AL21838 into the airline running from the…

I went out to our warehouse to take a look at the B&W Tow & Stow 3-Ball Mount #BWTS20049B referenced in your question. I measured a total length of right at 11 inches of the vertical adjustment shank on the ball mount. I have attached a short…

It sounds like you are trying to decide between the B&W Tow & Stow 3-Ball Mount part #BWTS20049B which has 7" of drop and the B&W Tow & Stow 3-Ball Mount part #BWTS20048B which has 4-1/2" of drop. If that is the case then…

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

Because the power leg is protected by a 20 amp circuit breaker, it's recommended that 12 gauge wire be used. I've provided a wiring diagram of the #LC298707 for you. You can see an install video by clicking the provided link.

If you are on the last adjustment of your 5 inch drop B and W Stow and Go you would want to go with the part #BWTS20049B especially once you lift the truck. On as big of a truck as what you have you would not have any issues with dragging either. I…

I am not aware of any legally mandated minimum ground clearance requirement for trailer hitch receivers in any states and my online research did not reveal any such laws. However, I did find on an internet forum for Sienna owners posts related to…

Your 2024 Ford F-250 is most likely going come with trailer wiring and a built in brake controller so those two things won't be needed but for a ball mount the B and W Tow N Stow part #BWTS20049B would be a great option that fits the 2.5 inch…

In order to choose the correct B&W Tow & Stow 3-Ball Mount you'll need to measure the distance from the ground to the top inside edge of the trailer hitch and then subtract the distance from the ground to the bottom of the trailer coupler…

To determine the amount of rise/drop you'll need, take a measurement from the inside top edge of the hitch receiver tube to the ground. Then, measure from the bottom of the trailer coupler to the ground. The difference between the two numbers…

You are right that the minimum recommended ground clearance is 11". Using the #BWTS20049B in its lowest position would leave one of the trailer balls lower than the vertical portion of the ball mount. There really is no work around in this case.…