How to Wire Up Snowmobile Trailer so that it Has Separate Turn Signals from Stoplights

Question:

Hi I am wiring up a snowmobile trailer. I want to put 3 amber led lights on each side and I want the middle one to blink. All of my lights are two wire. Is it possible to make this two wire like stay illuminated while park lights are on, and blink when I turn on my blinker. Looking forward to your response. Thanks!

asked by: Erik E

Expert Reply:

I am assuming the lights ground through their mounting hardware and the two wires ran to each are for the two illuminations. One brighter and one dimmer. If you wanted to run just the running light circuit and turn signal to just one of the lights you can do this but you have to install a signal converter so that you can get the turn signals by themselves.

For that you need the part # 118158 wired to your trailer's taillight wiring circuit.

I attached a picture that shows how this converter typically wires to a trailer.