Replacement Fulton Trailer Jack for Sled Bed trailer

Question

Question:

I can not seem to find any bolt on replacement the existing Fulton is mounted to a 2 7/8 by 6inch tongue

asked by: Tony R

0

Expert Reply:

We have the Fulton Marine Jack # HD50000101 which will fit trailer's with a frame up to 6 inches.

expert reply by: Charles S

0

Answer 1

The blue wire on a trailer is typically the output wire to the electric brake assemblies. If this is the case on your trailer then the wire should only have power when you are hooked up to the tow vehicle and are applying the brakes, either by…

view full answer...

Answer 2

The mounting plate for the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR has the following dimensions. I have included an image to show the measuring points. The holes are spread 5-1/2" wide with the vertical holes separated 1" on the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hello Greg, thanks for reaching out. Yes, the Trailer Valet JXS Drill Powered Drop Leg Trailer Jack w/ Footplate #TV36FR will indeed fit a 6-1/2" tall 4" wide I-beam frame. The bracket will fit frames up to 6-1/2" tall and 6" wide…

view full answer...

Replacement Fulton Trailer Jack for Sled Bed trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching